This DTC is stored when the windshield wiper motor assembly detects an internal malfunction.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | DTC Output from | Priority |
|---|---|---|---|---|---|---|
| B1370 | ECU Malfunction | DTC Detection Condition:
Ignition switch ON (IG+ voltage 9.5 V or higher) Malfunction Status:
·
Microcomputer malfunction ·
Temperature detection circuit malfunction ·
Angle detection circuit malfunction ·
Wiper motor activation circuit malfunction ·
Current detection circuit malfunction Malfunction Duration:
Malfunction determined if the status continues for 10 seconds or more |
Windshield wiper motor assembly | ○ | Wiper | A |
Pre-procedure1
None.
Procedure1
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
Post-procedure1
Turn the ignition switch to ON and wait for at least 10 seconds.
NEXT
Check for DTCs.
| Result | Proceed to |
|---|---|
| B1370 is not output | A |
| B1370 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B