Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VSC OFF SWITCH
RM37H0E _54 Brake _096746 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0454018 VSC OFF SWITCH G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VSC OFF SWITCH  INSPECTION  


PROCEDURE

Hide 84988L 1.INSPECT VSC OFF SWITCH

a.

Check the resistance.

i.
C425587C14
1.417,0.167 1.917,0.417 0.5,0.25 0.99,1.927 1.094,1.927 1.094,1.927 1.385,1.365 true 2.021,1.365 2.354,1.896 2.354,1.896 2.448,1.896 true 0.146,0.125 0.458,0.281 0.313,0.156 10 false *a 0.854,1.844 1.01,2.042 0.156,0.198 10 false + 2.51,1.823 2.667,2.021 0.156,0.198 10 false E 1.521,0.24 1.854,0.49 0.333,0.25 10 false D116
*a Component without harness connected
(VSC OFF Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(D116)Location & Routing

Click Connector(D116)Instrument Panel>Instrument Panel Wire>VSC Off Switch

D116-5(+) - D116-2(E) Switch pushed Below 1 Ω
D116-5(+) - D116-2(E) Switch not pushed 10 kΩ or higher


If the result is not as specified, replace the VSC OFF switch.



b.

Check the illumination.

i.
C425587C15
1.417,0.167 1.917,0.417 0.5,0.25 0.802,1.927 0.906,1.927 0.906,1.927 1.198,1.365 true 2.281,1.365 2.615,1.896 2.615,1.896 2.708,1.896 true 0.146,0.125 0.458,0.281 0.313,0.156 10 false *a 0.51,1.875 0.875,2.125 0.365,0.25 10 false ILL+ 2.771,1.833 3.135,2.094 0.365,0.26 10 false ILL- 1.521,0.24 1.938,0.49 0.417,0.25 10 false D116
*a Component without harness connected
(VSC OFF Switch)


Apply auxiliary battery voltage to the VSC OFF switch.

OK:
Tester Connection Condition Specified Condition

Click Location & Routing(D116)Location & Routing

Click Connector(D116)Instrument Panel>Instrument Panel Wire>VSC Off Switch

D116-6(ILL+) - D116-1(ILL-) D116-6(ILL+) - Auxiliary battery positive (+)
D116-1(ILL-) - Auxiliary battery negative (-)
Illuminates


If the result is not as specified, replace the VSC OFF switch.