Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE HOLD SWITCH
RM37H0E _54 Brake _096746 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0454019 BRAKE HOLD SWITCH G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE HOLD SWITCH  INSPECTION  


PROCEDURE

Hide 84390B 1.INSPECT BRAKE HOLD SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY)

a.
C398938C45
1.542,0.167 1.875,0.417 0.333,0.25 1.292,1.354 1.052,1.885 1.052,1.885 0.969,1.885 true 1.635,1.354 1.823,1.896 1.823,1.896 1.917,1.896 true 1.979,1.813 2.594,2.01 0.615,0.198 10 false +B 0.833,1.813 1.448,2.01 0.615,0.198 10 false E 0.115,0.135 0.427,0.333 0.313,0.198 10 false *a 1.594,0.24 2.01,0.49 0.417,0.25 10 false D51
*a Component without harness connected
(Brake Hold Switch (Electric Parking Brake Switch Assembly))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(D51)Location & Routing

Click Connector(D51)Instrument Panel>Instrument Panel Wire>Electric Parking Brake Switch Assembly

D51-10(+B) - D51-12(E) Switch pushed Below 1 Ω
D51-10(+B) - D51-12(E) Switch not pushed 10 kΩ or higher


If the result is not as specified, replace the brake hold switch.


b.
C398938C46
1.542,0.167 1.875,0.417 0.333,0.25 1.792,1.354 1.979,1.896 1.979,1.896 2.073,1.896 true 0.729,1.115 1.229,1.115 true 2.135,1.833 2.75,2.031 0.615,0.198 10 false ILL+ 0.406,1.052 1.021,1.25 0.615,0.198 10 false ILL- 0.115,0.135 0.427,0.333 0.313,0.198 10 false *a 1.594,0.24 2.01,0.49 0.417,0.25 10 false D51
*a Component without harness connected
(Brake Hold Switch (Electric Parking Brake Switch Assembly))


Apply battery voltage to the connector and check the illumination conditions.

OK:
Tester Connection Condition Specified Condition

Click Location & Routing(D51)Location & Routing

Click Connector(D51)Instrument Panel>Instrument Panel Wire>Electric Parking Brake Switch Assembly

D51-9(ILL+) - D51-6(ILL-) D51-9(ILL+) - Auxiliary battery positive (+)
D51-6(ILL-) - Auxiliary battery negative (-)
Illuminates


If the result is not as specified, replace the brake hold switch.