Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE FLUID
RM37H0E _54 Brake _096747 BRAKE SYSTEM (OTHER) _0454022 BRAKE FLUID G

BRAKE SYSTEM (OTHER)  BRAKE FLUID  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:

If using a dropper to adjust the fluid amount, make sure that the dropper has not been used with mineral oils, water or deteriorated brake fluid. Sealed areas may deteriorate and lead to fluid leaks, or the fluid may deteriorate and lead to decreased efficiency.


HINT:

If the brake fluid level is lower than the MIN line, inspect for brake fluid leaks and brake pad wear. After repair or replacement, adjust the brake fluid level in the reservoir as specified below.


PROCEDURE

Hide 1.INSPECT AND ADJUST FLUID LEVEL IN RESERVOIR (When Using the GTS)

a.

Select "Zero Down" on the "ECB Utility" screen.

Chassis > Brake/EPB > Utility
Tester Display
ECB Utility
50005 435 3617

b.

Enter "Next" and wait for 10 seconds.


c.
C447617C01
2.167,0.917 2.417,0.417 2.417,0.417 2.667,0.417 true 2.104,1.417 2.271,1.667 2.271,1.667 2.521,1.667 true 2.719,0.354 2.969,0.521 0.25,0.167 10 true *a 2.573,1.604 2.823,1.771 0.25,0.167 10 true *b
*a MAX Line
*b MIN Line


After the booster pump has stopped, check that the brake fluid level is between the MAX and MIN lines. If necessary, add brake fluid to the reservoir until the brake fluid level is at the MAX line.

Brake Fluid:

SAE J1703 or FMVSS No. 116 DOT3

SAE J1704 or FMVSS No. 116 DOT4



Hide 2.INSPECT AND ADJUST FLUID LEVEL IN RESERVOIR (When Not Using the GTS)

a.
C447617C03
2.104,1.417 2.271,1.667 2.271,1.667 2.521,1.667 true 2.063,1.021 2.813,1.021 true 2.865,0.958 3.115,1.125 0.25,0.167 10 true *a 2.573,1.604 2.823,1.771 0.25,0.167 10 true *b
*a Fluid Level Support Line
*b MIN Line


Check that the fluid level is above the MIN line with the ignition switch ON. Adjust the brake fluid level of the reservoir so that it is between the MIN line and fluid level support line.

Brake Fluid:

SAE J1703 or FMVSS No. 116 DOT3

SAE J1704 or FMVSS No. 116 DOT4