47070
1.INSPECT BRAKE BOOSTER PUMP ASSEMBLY
| *a | Component without harness connected
(Brake Booster Pump Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(A39)Location & Routingewd_type=routing;type=c;code=A39 Click Connector(A39)Engine Compartment>Front Compartment Main Wire / No. 3 Front Compartment Wire / No. 4 Front Compartment Wire>Brake Booster Pump Assemblyewd_type=component;type=c;code=A39;pinno=1,2 |
||
| A39-1 (BM1) - A39-2 (GND1) | Always | 10 Ω or less |