CHECK STEREO COMPONENT EQUALIZER ASSEMBLY
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| D104-1 (GND) - Body ground | Ground | Always | Below 1 Ω |
| D104-2(SPO+) - D104-10(SPO-) | Sound signal | Simulated EV sounds being output | A waveform synchronized with sound is output |
| D104-3 (+B) - Body ground | Power supply | Ignition switch off | 11 to 14 V |
| D104-4 (CANH) - Body ground | CAN communication signal | - | - |
| D104-5 (SW) - Body ground | ASC switch signal | Ignition switch ON, ASC Switch (vehicle sound switch) pushed | 11 to 14 V |
| Ignition switch ON, ASC Switch (vehicle sound switch) not pushed | Below 1 V | ||
| D104-7 (IND) - Body ground | ASC switch indicator signal | Ignition switch ON, ASC Switch (vehicle sound switch) on | 8 to 14 V |
| Ignition switch ON, ASC Switch (vehicle sound switch) off | Below 1 V | ||
| D104-9 (GND1) - Body ground | Ground | Always | Below 1 Ω |
| D104-11 (IG) - Body ground | IG power supply | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | ||
| D104-12 (CANL) - Body ground | CAN communication signal | - | - |
| D104-16 (SPO+) - D104-15 (SPO-) | Sound signal | Simulated EV sounds being output | A waveform synchronized with sound is output |