This circuit is the power source circuit for the stereo component equalizer assembly.
Inspect the fuses for circuits related to this system before performing the following procedure.
Disconnect the D104 stereo component equalizer assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D104)Location & Routingewd_type=routing;type=c;code=D104 Click Connector(D104)Instrument Panel>Instrument Panel Wire>Stereo Component Equalizer Assemblyewd_type=component;type=c;code=D104;pinno=1,9 |
||
| D104-1 (GND) - Body ground | Always | Below 1 Ω |
| D104-9 (GND1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D104)Location & Routingewd_type=routing;type=c;code=D104 Click Connector(D104)Instrument Panel>Instrument Panel Wire>Stereo Component Equalizer Assemblyewd_type=component;type=c;code=D104;pinno=3,11 |
||
| D104-3 (+B) - Body ground | Ignition switch off | 11 to 14 V |
| D104-11 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| D104-11 (IG) - Body ground | Ignition switch off | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG