CUSTOMIZE TOYOTA MULTI OPERATION TOUCH SYSTEM
When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current settings before customizing.
When troubleshooting a function, first make sure that the function is set to the default setting.
Customizing with the GTS.
Enter the following menus: Customize Setting / Others.
Select the setting by referring to the table below.
| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| Touch Panel Reaction Time Adjust (Multi Operation) | Touch panel reaction time | 40ms | 00:40ms,01:140ms,10:170ms,11:200ms | Integration control sub-assembly |
Customizing with the integration control sub-assembly
Turn the ignition switch to ON.
Enter the "Setting" menu.
Select the setting by referring to the table below.
| Display | Description | Default | Setting | Relevant ECU |
|---|---|---|---|---|
| Slide Operation | ·
ON: Flick function enabled ·
OFF: Flick function disabled |
ON | ON or OFF | Integration control sub-assembly |