Disconnect the D105 integration control sub-assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D105)Location & Routingewd_type=routing;type=c;code=D105 Click Connector(D105)Instrument Panel>Instrument Panel Wire>Integration Control Sub-Assemblyewd_type=component;type=c;code=D105;pinno=5 |
||
| D105-5 (ILL+) - Body Ground | Ignition switch ON
Light control switch in tail or head |
11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D105)Location & Routingewd_type=routing;type=c;code=D105 Click Connector(D105)Instrument Panel>Instrument Panel Wire>Integration Control Sub-Assemblyewd_type=component;type=c;code=D105;pinno=20 |
||
| D105-20 (GND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG