83950M
1.INSPECT TELLTALE LIGHT ASSEMBLY (SECURITY INDICATOR LIGHT ASSEMBLY)
| *a | Component without harness connected
(Telltale Light Assembly (Security Indicator Light Assembly)) |
Apply auxiliary battery voltage to the connector and check the security indicator illumination conditions.
| Tester Connection | Specified Condition |
|---|---|
|
Click Location & Routing(D38)Location & Routingewd_type=routing;type=c;code=D38 Click Connector(D38)Instrument Panel>Instrument Panel Wire>Telltale Light Assemblyewd_type=component;type=c;code=D38;pinno=10,6 |
|
| Auxiliary battery positive (+) - D38-10 (LP)
Auxiliary battery negative (-) - D38-6 (E) |
Security indicator illuminates |
If the result is not as specified, replace the telltale light assembly (security indicator light assembly).