Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for eCall)
RM37H0E _56 Audio / Visual / Telematics _095262 TELEMATICS _0447865 TELEMATICS SYSTEM(for eCall) C

TELEMATICS  TELEMATICS SYSTEM(for eCall)  B15CC49  Backup Battery Internal Electronic Failure  


DESCRIPTION

This DTC is stored when the telematics transceiver detects one of the following:

·

The mobilephone battery voltage drops or the mobilephone battery malfunctions.

·

The mobilephone battery temperature is (temporarily) high.


DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
B15CC49 Backup Battery Internal Electronic Failure Mobilephone battery malfunction
·

Mobilephone battery

·

Telematics transceiver


Telematics A

CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Telematics System.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for eCall)>PRECAUTION


PROCEDURE

1.CHECK DTC

Pre-procedure1

a.

Turn the ignition switch to ON and wait for 10 seconds or more.


b.

Clear the DTCs.

Body Electrical > Telematics > Clear DTCs
50002 459

Procedure1

a.

Check for DTCs and check that no DTCs are output.

Body Electrical > Telematics > Trouble Codes
50001 459
Result:
Result Proceed to
DTCs are not output A
DTCs are output B



Post-procedure1

a.

None



A

B

2.CHECK MOBILEPHONE BATTERY
2.CHECK MOBILEPHONE BATTERY

Pre-procedure1

a.

Replace the mobilephone battery with a normal one and check if the same problem occurs again.

HINT:

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL


NOTICE:

After replacing the mobilephone battery, perform initialization.


HINT:

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for eCall)>INITIALIZATION



b.

Clear the DTCs.

Body Electrical > Telematics > Clear DTCs
50002 459

Procedure1

a.

Recheck for DTCs and check that no DTCs are output.

Body Electrical > Telematics > Trouble Codes
50001 459
Result:
Result Proceed to
DTCs are not output A
DTCs are output B



Post-procedure1

a.

None



A

B

3.REPLACE TELEMATICS TRANSCEIVER
3.REPLACE TELEMATICS TRANSCEIVER
a.

Replace the telematics transceiver with a new one.

HINT:

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL



Result:
Proceed to
NEXT



NEXT