If there is an open in a speaker circuit, the telematics transceiver detects it and stops output to the speakers.
Thus sound cannot be heard from the speakers even if there is no malfunction in the telematics transceiver or No. 4 speaker with box assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| B1AC07F | Speaker Cable Connection Actuator Stuck Off | The malfunction is detected in the telephone speaker circuit for approximately 10 seconds or more. | ·
No. 4 speaker with box assembly ·
Telematics transceiver ·
Harness or connector |
Telematics | A |
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Telematics System.
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for eCall)>PRECAUTION
When replacing the telematics transceiver, make sure to replace it with a new one.
Pre-procedure1
Turn the ignition switch to ON and wait for 10 seconds.
Clear the DTCs.
Procedure1
Check for DTCs and check that no DTCs are output.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
Post-procedure1
None
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Pre-procedure1
Disconnect the D2 No. 4 speaker with box assembly connector.
Disconnect the D72 telematics transceiver connector.
Procedure1
Measure the resistance according to the value (s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D2,D72)Location & Routingewd_type=routing;type=c,c;code=D2,D72 Click Connector(D2)Instrument Panel>Instrument Panel Wire>No. 4 Speaker with Box Assemblyewd_type=component;type=c;code=D2;pinno=4,2 Click Connector(D72)Instrument Panel>Instrument Panel Wire>Telematics Transceiverewd_type=component;type=c;code=D72;pinno=3,4 |
||
| D2-4 (+) - D72-3 (SPO+) | Always | Below 1 Ω |
| D2-2 (-) - D72-4 (SPO-) | Always | Below 1 Ω |
| D2-4 (+) or D72-3 (SPO+) - Body ground | Always | 10 kΩ or higher |
| D2-2 (-) or D72-4 (SPO-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG
Pre-procedure1
Replace the No. 4 speaker with box assembly.
Clear the DTCs.
Procedure1
Recheck for DTCs and check that no DTCs are output.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
Post-procedure1
None
A
B
Replace the telematics transceiver with a new one.
| Proceed to |
|---|
| NEXT |
NEXT