INITIALIZE ROOF SUNSHADE SYSTEM
When the sliding roof drive gear sub-assembly or sliding roof housing sub-assembly is replaced or removed and installed, the sliding roof drive gear sub-assembly requires initialization (pulse sensor initial position setting), as the roof sunshade position cannot be determined. If initialization is not performed, the auto open and close function and jam protection function may not operate, or the roof sunshade may move in reverse or become misaligned.
During initialization, do not apply a physical shock, such as opening/closing a door or driving the vehicle at 5 km/h (3 mph) or more, to the vehicle.
The roof sunshade switch is attached to the map light assembly.
Perform initialization according to the table below.
| Condition of Roof Sunshade | Proceed to |
|---|---|
| Auto operation does not operate. | Procedure A |
| Auto operation operates normally, but the roof sunshade does not stop at the correct fully closed position. | Procedure B |
| Auto operation operates normally, but the roof sunshade erroneously reverses operation while closed. | Procedure B |
Procedure A
Turn the ignition switch to ON.
Press and hold the close switch until the following operation completes.
The roof sunshade moves in the following order: starts closing → stops at the fully closed position → starts opening* → stops at the correct fully closed position (completion of initialization).
If the close switch is released before the initialization completes, press and hold the switch again until this operation completes.
*: The opening operation may not be noticeable as the opening distance is quite short.
Confirm that the roof sunshade auto function operates normally.
Procedure B
Turn the ignition switch to ON.
Press and hold the close switch for 0.3 seconds or more to start the roof sunshade auto function.
Wait until the auto operation completes, and press and hold the close switch until the following operation completes.
The roof sunshade moves in the following order: pauses approximately 10 seconds*1 → starts closing → stops at the fully closed position → starts opening*2 → stops at the correct fully closed position (completion of initialization).
If the close switch is released before the initialization completes, turn the ignition switch off and perform procedure B again.
*1: If the roof sunshade does not start closing after pausing for approximately 10 seconds, release and press the close switch until this operation completes.
*2: The opening operation may not be noticeable as the opening distance is quite short.
Confirm that the roof sunshade auto function operates normally.