Home › Vehicle Interior › INTERIOR PANELS / TRIM › ROOF SUNSHADE SYSTEM
RM37H0E _58 Vehicle Interior _095304 INTERIOR PANELS / TRIM _0454452 ROOF SUNSHADE SYSTEM U

INTERIOR PANELS / TRIM  ROOF SUNSHADE SYSTEM  TERMINALS OF ECU  


CHECK SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


B417851N88
3.375,0.125 3.792,0.417 0.417,0.292 3.521,0.188 3.833,0.385 0.313,0.198 10 false H4

a.

Disconnect the H4 sliding roof drive gear sub-assembly connector.


b.

Measure the resistance and voltage according to the value(s) in the table below.

HINT:

Measure the values on the wire harness side with the connector disconnected.


Terminal No. (Symbol) Terminal Description Condition Specified Condition
H4-1 (B) - H4-2 (E) Auxiliary battery power supply Ignition switch off 11 to 14 V
H4-6 (IG) - H4-2 (E) IG power supply Ignition switch ON 11 to 14 V
Ignition switch off Below 1 V
H4-2 (E) - Body ground Ground Always Below 1 Ω


c.

Reconnect the H4 sliding roof drive gear sub-assembly connector.


d.

Measure the voltage according to the value(s) in the table below.

Terminal No. (Symbol) Terminal Description Condition Specified Condition
H4-5 (OPN) - H4-2 (E) Roof sunshade operation signal (open) Ignition switch ON, OPEN switch off → on 11 to 14 V → Below 1 V
H4-9 (CLS) - H4-2 (E) Roof sunshade operation signal (close) Ignition switch ON, CLOSE switch off → on 11 to 14 V → Below 1 V