Home › Power Source / Network › BATTERY / CHARGING › AUXILIARY BATTERY
RM37H0E _57 Power Source / Network _097006 BATTERY / CHARGING _0454601 AUXILIARY BATTERY F

BATTERY / CHARGING  AUXILIARY BATTERY  WHEN AUXILIARY BATTERY IS DISCHARGED  


WHEN AUXILIARY BATTERY IS DISCHARGED


NOTICE:

Never use a quick charger.


HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

The following problems indicate that the auxiliary battery is discharged:

-

No display appears on the instrument panel when the ignition switch is turned to ON.

-

The FC system does not start.

-

The headlights are dim.

-

The sound from the horn is weak.

-

"Low Auxiliary Battery See Owner's Manual" is displayed on the multi-information display.


·

The booster terminal cannot be used to rescue a vehicle with a discharged auxiliary battery.



a.

Set the shift position to P (park) and engage the parking brake.


b.

Make sure to carry the electrical key transmitter sub-assembly and check that the ignition switch is off.


c.

Remove the No. 2 relay block cover.


d.
A479517C01
0,0 0,0 false
V113147

Remove in this Direction


Open the booster terminal cover.


e.

Using booster cables, connect the 12 V auxiliary battery of the rescue vehicle to the auxiliary battery of the stalled vehicle as shown in the illustration.

A479519C01
6.698,0.948 6.833,0.396 6.833,0.396 6.688,0.396 true 5.677,3.344 5.927,3.344 false 6.542,0.302 6.75,0.469 0.208,0.167 10 true *a 5.51,3.26 5.75,3.49 0.24,0.229 10 false *b
*a Booster Terminal *b Auxiliary Battery of Rescue Vehicle


Connecting Sequence Connecting Location
1 Booster terminal of stalled vehicle
2 Positive (+) auxiliary battery terminal of rescue vehicle
3 Negative (-) auxiliary battery terminal of rescue vehicle
4 Position shown in the illustration on stalled vehicle
NOTICE:

Connect it not to pinch other parts.




f.

Start the engine of the rescue vehicle and run its engine a slightly elevated speed for approximately 5 minutes in order to charge the auxiliary battery of the stalled vehicle.


g.

With the ignition switch off, open and close any door.


h.

With the engine of the rescue vehicle being run at a slightly elevated speed, turn the ignition switch to ON (READY) from ON to start the FC system. [*1]

NOTICE:

Immediately disconnect the booster cables in the reverse order of connection after the FC system has started.


HINT:
·

If the FCd system does not start even after the auxiliary battery returns to normal, ensure the shift position is P (park) and repeat the procedure from [*1].

·

Make sure to perform all necessary procedures for when the auxiliary battery is returned to normal after being depleted.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

·

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART