Home › Vehicle Exterior › WINDOW / GLASS › FRONT PASSENGER SIDE POWER WINDOW SWITCH
RM37H0E _59 Vehicle Exterior _095305 WINDOW / GLASS _0454678 FRONT PASSENGER SIDE POWER WINDOW SWITCH G

WINDOW / GLASS  FRONT PASSENGER SIDE POWER WINDOW SWITCH  INSPECTION  


PROCEDURE

Hide 84810 1.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY

a.

Inspect the power window regulator switch assembly.

i.
B563160C22
1.427,0.302 1.844,0.552 0.417,0.25 0.75,1.573 1.135,1.24 true 1.25,1.667 1.302,1.24 true 1.698,1.625 1.625,1.24 true 2.094,1.635 1.802,1.24 true 0.521,0.458 0.833,0.615 0.313,0.156 10 false *a 0.375,1.594 0.875,1.76 0.5,0.167 10 false AUTO 0.969,1.677 1.365,1.854 0.396,0.177 10 false GND 1.625,1.688 1.885,1.854 0.26,0.167 10 false UP 2.063,1.677 2.583,1.833 0.521,0.156 10 false DOWN 1.552,0.354 1.865,0.51 0.313,0.156 10 false E13
*a Component without harness connected
(Power Window Regulator Switch Assembly)


for LHD:

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(E13)Location & Routing

Click Connector(E13)Body>Front Door Wire LH / Front Door Wire RH>Power Window Regulator Switch Assembly

E13-5 (UP) - E13-7 (GND) UP(MANUAL) Below 1 Ω
E13-5 (UP) - E13-7 (GND) OFF 10 kΩ or higher
E13-4 (DOWN) - E13-7 (GND) DOWN(MANUAL) Below 1 Ω
E13-4 (DOWN) - E13-7 (GND) OFF 10 kΩ or higher
E13-5 (UP) - E13-7 (GND) UP(AUTO) Below 1 Ω
E13-5 (UP) - E13-7 (GND) OFF 10 kΩ or higher
E13-8 (AUTO) - E13-7 (GND) UP(AUTO) Below 1 Ω
E13-8 (AUTO) - E13-7 (GND) OFF 10 kΩ or higher
E13-4 (DOWN) - E13-7 (GND) DOWN(AUTO) Below 1 Ω
E13-4 (DOWN) - E13-7 (GND) OFF 10 kΩ or higher
E13-8 (AUTO) - E13-7 (GND) DOWN(AUTO) Below 1 Ω
E13-8 (AUTO) - E13-7 (GND) OFF 10 kΩ or higher


If the result is not as specified, replace the power window regulator switch assembly.


ii.
B563160C18
1.427,0.302 1.844,0.552 0.417,0.25 0.75,1.573 1.135,1.24 true 1.25,1.667 1.302,1.24 true 1.698,1.625 1.625,1.24 true 2.094,1.635 1.802,1.24 true 0.521,0.458 0.833,0.615 0.313,0.156 10 false *a 0.375,1.594 0.875,1.76 0.5,0.167 10 false AUTO 0.969,1.677 1.365,1.854 0.396,0.177 10 false GND 1.625,1.688 1.885,1.854 0.26,0.167 10 false UP 2.063,1.677 2.583,1.833 0.521,0.156 10 false DOWN 1.552,0.354 1.865,0.51 0.313,0.156 10 false E31
*a Component without harness connected
(Power Window Regulator Switch Assembly)


for RHD:

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(E31)Location & Routing

Click Connector(E31)Body>Front Door Wire LH / Front Door Wire RH>Power Window Regulator Switch Assembly

E31-5 (UP) - E31-7 (GND) UP(MANUAL) Below 1 Ω
E31-5 (UP) - E31-7 (GND) OFF 10 kΩ or higher
E31-4 (DOWN) - E31-7 (GND) DOWN(MANUAL) Below 1 Ω
E31-4 (DOWN) - E31-7 (GND) OFF 10 kΩ or higher
E31-5 (UP) - E31-7 (GND) UP(AUTO) Below 1 Ω
E31-5 (UP) - E31-7 (GND) OFF 10 kΩ or higher
E31-8 (AUTO) - E31-7 (GND) UP(AUTO) Below 1 Ω
E31-8 (AUTO) - E31-7 (GND) OFF 10 kΩ or higher
E31-4 (DOWN) - E31-7 (GND) DOWN(AUTO) Below 1 Ω
E31-4 (DOWN) - E31-7 (GND) OFF 10 kΩ or higher
E31-8 (AUTO) - E31-7 (GND) DOWN(AUTO) Below 1 Ω
E31-8 (AUTO) - E31-7 (GND) OFF 10 kΩ or higher


If the result is not as specified, replace the power window regulator switch assembly.



b.

Check the illumination.

i.
B563160C23
1.427,0.302 1.844,0.552 0.417,0.25 1.844,1.625 1.948,1.24 true 2.615,1.635 2.323,1.24 true 0.521,0.458 0.833,0.615 0.313,0.156 10 false *a 1.698,1.646 2.021,1.823 0.323,0.177 10 false ILL+ 2.635,1.656 3.156,1.813 0.521,0.156 10 false ILL- 1.531,0.354 1.844,0.51 0.313,0.156 10 false E13
*a Component without harness connected
(Power Window Regulator Switch Assembly)


for LHD:

Apply auxiliary battery voltage to the connector and check the illumination conditions.

OK:
Tester Connection Specified Condition

Click Location & Routing(E13)Location & Routing

Click Connector(E13)Body>Front Door Wire LH / Front Door Wire RH>Power Window Regulator Switch Assembly

E13-3 (ILL+) - Auxiliary battery positive (+)
E13-1 (ILL-) - Auxiliary battery negative (-)
Illuminates


If the result is not as specified, replace the power window regulator switch assembly.


ii.
B563160C21
1.427,0.302 1.844,0.552 0.417,0.25 1.844,1.625 1.948,1.24 true 2.615,1.635 2.323,1.24 true 0.521,0.458 0.833,0.615 0.313,0.156 10 false *a 1.698,1.646 2.021,1.823 0.323,0.177 10 false ILL+ 2.635,1.656 3.156,1.813 0.521,0.156 10 false ILL- 1.531,0.354 1.844,0.51 0.313,0.156 10 false E31
*a Component without harness connected
(Power Window Regulator Switch Assembly)


for RHD:

Apply auxiliary battery voltage to the connector and check the illumination conditions.

OK:
Tester Connection Specified Condition

Click Location & Routing(E31)Location & Routing

Click Connector(E31)Body>Front Door Wire LH / Front Door Wire RH>Power Window Regulator Switch Assembly

E31-3 (ILL+) - Auxiliary battery positive (+)
E31-1 (ILL-) - Auxiliary battery negative (-)
Illuminates


If the result is not as specified, replace the power window regulator switch assembly.