Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT EVAPORATOR TEMPERATURE SENSOR
RM37H0E _58 Vehicle Interior _095300 HEATING / AIR CONDITIONING _0448159 FRONT EVAPORATOR TEMPERATURE SENSOR G

HEATING / AIR CONDITIONING  FRONT EVAPORATOR TEMPERATURE SENSOR  INSPECTION  


PROCEDURE

Hide 88625 1.INSPECT NO. 1 COOLER THERMISTOR

a.
E126546C06
0.406,0.875 0.563,0.531 false 2.042,0.188 2.354,0.344 0.313,0.156 10 *a 0.531,0.344 0.844,0.5 0.313,0.156 10 *b 0.031,2.875 0.344,3.031 0.313,0.156 10 *c 1.906,4.438 2.219,4.594 0.313,0.156 10 *d 0.24,1.885 0.854,2.083 0.615,0.198 10 10.0 0.302,2.083 0.917,2.281 0.615,0.198 10 9.0 0.302,2.313 0.917,2.51 0.615,0.198 10 8.0 0.302,2.542 0.917,2.74 0.615,0.198 10 7.0 0.302,2.75 0.917,2.948 0.615,0.198 10 6.0 0.302,2.969 0.917,3.167 0.615,0.198 10 5.0 0.313,3.188 0.927,3.385 0.615,0.198 10 4.0 0.313,3.406 0.927,3.604 0.615,0.198 10 3.0 0.313,3.615 0.927,3.813 0.615,0.198 10 2.0 0.313,3.833 0.927,4.031 0.615,0.198 10 1.0 0.313,4.042 0.927,4.24 0.615,0.198 10 0.0 0.448,4.188 1.063,4.385 0.615,0.198 10 -10 1.26,4.188 1.875,4.385 0.615,0.198 10 0 1.927,4.188 2.542,4.385 0.615,0.198 10 10 2.635,4.188 3.25,4.385 0.615,0.198 10 20 3.198,4.188 3.427,4.375 0.229,0.188 10 30
*a Component without harness connected
(No. 1 Cooler Thermistor)
*b Sensing Portion
*c Resistance (kΩ)
*d Temperature (°C (°F))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 -10°C (14°F) 7.30 to 9.10 kΩ
1 - 2 -5°C (23°F) 5.65 to 6.95 kΩ
1 - 2 0°C (32°F) 4.40 to 5.35 kΩ
1 - 2 5°C (41°F) 3.40 to 4.15 kΩ
1 - 2 10°C (50°F) 2.70 to 3.25 kΩ
1 - 2 15°C (59°F) 2.14 to 2.58 kΩ
1 - 2 20°C (68°F) 1.71 to 2.05 kΩ
1 - 2 25°C (77°F) 1.38 to 1.64 kΩ
1 - 2 30°C (86°F) 1.11 to 1.32 kΩ


NOTICE:
·

Hold the sensor only by its connector. Touching the sensor may change the resistance value.

·

Perform the measurement once the sensor has adapted to the ambient temperature.



HINT:

As the temperature increases, the resistance decreases (see the graph).


If the result is not as specified, replace the No. 1 cooler thermistor.