Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › PEDESTRIAN PROTECTION SYSTEM
RM37H0E _58 Vehicle Interior _095287 SUPPLEMENTAL RESTRAINT SYSTEMS _0454682 PEDESTRIAN PROTECTION SYSTEM D

SUPPLEMENTAL RESTRAINT SYSTEMS  PEDESTRIAN PROTECTION SYSTEM  OPERATION CHECK  


PRECAUTION FOR OPERATION CHECK


CAUTION:
C376913

Use the correct procedure to replace the pedestrian protection system parts.



CHECK POP UP HOOD WARNING LIGHT


C382018C01
0.135,0.115 0.448,0.313 0.313,0.198 10 false *a
*a Pop Up Hood Warning Light


a.

Primary check

i.

Turn the ignition switch to ON and check that the pop up hood warning light turn on.


ii.

Turn the ignition switch off. Wait for at least 2 seconds, and then turn the ignition switch to ON. The pop up hood warning light comes on for approximately 6 seconds and diagnosis of the pedestrian protection system is performed.

NOTICE:

Turn the ignition switch off when the auxiliary battery is connected.


HINT:
·

If the warning light remains on for approximately 6 seconds or more after the ignition switch has been turned to ON, there may be a malfunction with the SRS pedestrian protection system.

·

If the warning light occasionally turns on approximately 6 seconds or more after the ignition switch has been turned to ON, there may be a short to +B, short to ground or an open in the pop up hood warning light circuit.

·

If the warning light illuminates after turning the ignition switch off or to ACC, there may be a malfunction in the power source circuit or combination meter assembly.

·

The pop up hood warning light turns off, and then turns on. This blinking pattern indicates a source voltage drop. The pop up hood warning light turns off 6 to 10 seconds after the source voltage returns to normal.






CHECK POP UP HOOD LIFTER ASSEMBLY


a.

If any defects are found, replace the pop up huudo lifter assembly with a new one.

·

Cracks on the cylinder

·

Dents on the cylinder

·

Chips on the cylinder

·

Cracks or other damage to the connector

·

Deformation or cracks on the pop up hood lifter assembly bracket




CHECK PEDESTRIAN DETECTION SENSOR


a.

Check for DTCs and freeze frame data.



CHECK HARNESS AND CONNECTOR


a.

Check for DTCs and freeze frame data.



INSPECT PEDESTRIAN DETECTION SYSTEM COMPONENTS


a.

Inspect the SRS parts in table below.

Component to Inspect Procedure
Pop Up Hood Lifter Assembly
1.

Perform a diagnostic system check.

2.

Visually check for defects with the pop up hood lifter assembly removed from the vehicle.

HINT:

The defects are as follows:

·

Cracks on the cylinder

·

Dents on the cylinder

·

Chips on the cylinder

·

Cracks or other damage to the connector

·

Deformation or cracks on the pop up hood lifter assembly bracket



OK:

No defects are found.


If any defects are found, replace the pop up hood lifter assembly with a new one.


Airbag ECU assembly
1.

Check for DTCs and freeze frame data.


Pedestrian Detection Chamber Assembly (Pedestrian Protection Sensor)
Harness and connector