84490L
1.INSPECT ADVANCED PARK MAIN SWITCH
| *a | Component without harness connected
(Advanced Park Main Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D6)Location & Routingewd_type=routing;type=c;code=D6 Click Connector(D6)Instrument Panel>Instrument Panel Wire>Advanced Parking Switch Assemblyewd_type=component;type=c;code=D6;pinno=5,2 |
||
| D6-5 (IG) - D6-2 (E) | Switch pressed | Below 1 Ω |
| D6-5 (IG) - D6-2 (E) | Switch not pressed | 10 kΩ or higher |
If the result is not as specified, replace the advanced park main switch.
| *a | Component without harness connected
(Advanced Park Main Switch) |
Check the illumination.
| Tester Connection | Specified Condition |
|---|---|
|
Click Location & Routing(D6)Location & Routingewd_type=routing;type=c;code=D6 Click Connector(D6)Instrument Panel>Instrument Panel Wire>Advanced Parking Switch Assemblyewd_type=component;type=c;code=D6;pinno=6,1 |
|
| D6-6 (ILL+) - Auxiliary battery positive (+)
D6-1 (ILL-) - Auxiliary battery negative (-) |
Illuminates |
If the result is not as specified, replace the advanced park main switch.