84721B
1.INSPECT PANORAMIC VIEW MONITOR SWITCH
| *a | Component without harness connected
(Panoramic View Monitor Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D112)Location & Routingewd_type=routing;type=c;code=D112 Click Connector(D112)Instrument Panel>Instrument Panel Wire>Panoramic View Monitor Switchewd_type=component;type=c;code=D112;pinno=5,2 |
||
| D112-5(D) - D112-2(E) | Panoramic view monitor switch on (not protruding) | Below 1 Ω |
| D112-5(D) - D112-2(E) | Panoramic view monitor switch off (protruding) | 10 kΩ or higher |
If the result is not as specified, replace the panoramic view monitor switch.
| *a | Component without harness connected
(Panoramic View Monitor Switch) |
Check the illumination.
Apply auxiliary battery voltage to the connector and check the illumination conditions.
| Tester Connection | Specified Condition |
|---|---|
|
Click Location & Routing(D112)Location & Routingewd_type=routing;type=c;code=D112 Click Connector(D112)Instrument Panel>Instrument Panel Wire>Panoramic View Monitor Switchewd_type=component;type=c;code=D112;pinno=6,1 |
|
| Auxiliary battery positive (+) - D112-6(ILL+)
Auxiliary battery negative (-) - D112-1(ILL-) |
Illuminates |
If the result is not as specified, replace the panoramic view monitor switch.