87510L
1.INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY LH (for LHD)
| *a | Connecter A |
| *b | Component without harness connected
(Front Seat Cushion Heater Assembly LH) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(L35)Location & Routingewd_type=routing;type=c;code=L35 Click Connector(L35)Seat>Front Seat Wire RH / No. 2 Front Seat Wire LH / No. 2 Front Seat Wire RH>Front Seat Cushion Heater Assembly LHewd_type=component;type=c;code=L35;pinno=1,2,6,4,5 |
||
| L35-1 - A-1 | Always 20°C (68°F) | Below 1 Ω |
| L35-1 - A-2 | Always 20°C (68°F) | 3.20 to 3.83 Ω |
| L35-2 - L35-6 | Always 20°C (68°F) | Below 1 Ω |
| L35-2 - A-2 | Always 20°C (68°F) | Below 1 Ω |
| L35-4 - L35-5 | Always 20°C (68°F) | 11.94 to 12.24 kΩ |
| A-1 - A-2 | Always 20°C (68°F) | 3.26 to 3.90 Ω |
If the result is not as specified, replace the front seat cushion heater assembly LH.
87510K
2.INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY RH (for LHD)
| *a | Connecter A |
| *c | Component without harness connected
(Front Seat Cushion Heater Assembly RH) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(L10)Location & Routingewd_type=routing;type=c;code=L10 Click Connector(L10)Seat>Front Seat Wire RH / No. 2 Front Seat Wire LH / No. 2 Front Seat Wire RH>Front Seat Cushion Heater Assembly RHewd_type=component;type=c;code=L10;pinno=1,2,6,4,5 |
||
| L10-1 - A-1 | Always 20°C (68°F) | Below 1 Ω |
| L10-1 - A-2 | Always 20°C (68°F) | 3.20 to 3.83 Ω |
| L10-2 - L10-6 | Always 20°C (68°F) | Below 1 Ω |
| L10-2 - A-2 | Always 20°C (68°F) | Below 1 Ω |
| L10-4 - L10-5 | Always 20°C (68°F) | 11.94 to 12.24 kΩ |
| A-1 - A-2 | Always 20°C (68°F) | 3.26 to 3.90 Ω |
If the result is not as specified, replace the front seat cushion heater assembly RH.
87510K
3.INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY RH (for RHD)
| *a | Connecter A |
| *c | Component without harness connected
(Front Seat Cushion Heater Assembly RH) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(L10)Location & Routingewd_type=routing;type=c;code=L10 Click Connector(L10)Seat>Front Seat Wire RH / No. 2 Front Seat Wire LH / No. 2 Front Seat Wire RH>Front Seat Cushion Heater Assembly RHewd_type=component;type=c;code=L10;pinno=1,2,6,4,5 |
||
| L10-1 - A-1 | Always 20°C (68°F) | Below 1 Ω |
| L10-1 - A-2 | Always 20°C (68°F) | 3.20 to 3.83 Ω |
| L10-2 - L10-6 | Always 20°C (68°F) | Below 1 Ω |
| L10-2 - A-2 | Always 20°C (68°F) | Below 1 Ω |
| L10-4 - L10-5 | Always 20°C (68°F) | 11.94 to 12.24 kΩ |
| A-1 - A-2 | Always 20°C (68°F) | 3.26 to 3.90 Ω |
If the result is not as specified, replace the front seat cushion heater assembly RH.
87510L
4.INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY LH (for RHD)
| *a | Connecter A |
| *b | Component without harness connected
(Front Seat Cushion Heater Assembly LH) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(L35)Location & Routingewd_type=routing;type=c;code=L35 Click Connector(L35)Seat>Front Seat Wire RH / No. 2 Front Seat Wire LH / No. 2 Front Seat Wire RH>Front Seat Cushion Heater Assembly LHewd_type=component;type=c;code=L35;pinno=1,2,6,4,5 |
||
| L35-1 - A-1 | Always 20°C (68°F) | Below 1 Ω |
| L35-1 - A-2 | Always 20°C (68°F) | 3.20 to 3.83 Ω |
| L35-2 - L35-6 | Always 20°C (68°F) | Below 1 Ω |
| L35-2 - A-2 | Always 20°C (68°F) | Below 1 Ω |
| L35-4 - L35-5 | Always 20°C (68°F) | 11.94 to 12.24 kΩ |
| A-1 - A-2 | Always 20°C (68°F) | 3.26 to 3.90 Ω |
If the result is not as specified, replace the front seat cushion heater assembly LH.