These DTCs are stored when a malfunction occurs in the multi-display assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| B15A6 | Display Malfunction | When any of the following conditions is met:
·
RAM error ·
Drawing controller malfunction ·
Internal hard drive malfunction |
Multi-display assembly | Navigation System | A |
| B15B0 | Display Screen Malfunction | Picture circuit (TFT unit) malfunction | Multi-display assembly | Navigation System | A |
Pre-procedure1
Clear the DTCs.
Procedure1
Recheck for DTCs and check that no DTCs are output.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
Post-procedure1
None
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B