Check that the voice guidance setting is not off.
Voice guidance setting is not off.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the D62 radio receiver assembly connector.
Disconnect the D65 navigation ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D62,D65)Location & Routingewd_type=routing;type=c,c;code=D62,D65 Click Connector(D62)Instrument Panel>Instrument Panel Wire>Radio Receiver Assemblyewd_type=component;type=c;code=D62;pinno=22,23 Click Connector(D65)Instrument Panel>Instrument Panel Wire>Navigation ECU Assemblyewd_type=component;type=c;code=D65;pinno=6,7,8 |
||
| D62-22 (SI+) - D65-6 (VOI+) | Always | Below 1 Ω |
| D62-23 (SI-) - D65-7 (VOI-) | Always | Below 1 Ω |
| D62-22 (SI+) or D65-6 (VOI+) - Body ground | Always | 10 kΩ or higher |
| D62-23 (SI-) or D65-7 (VOI-) - Body ground | Always | 10 kΩ or higher |
| D65-8 (SLD1) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG