Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM
RM37H0E _56 Audio / Visual / Telematics _095261 NAVIGATION / MULTI INFO DISPLAY _0453794 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  USB Audio System Recognition/Play Error  


DESCRIPTION

When a USB device or "iPod" is connected to the USB jack of the No. 1 stereo jack adapter assembly, it must have playable files. The device must also communicate with and be recognized by the radio receiver assembly. This diagnostic procedure is for when a device is not recognized, or files from the device cannot be played normally.

WIRING DIAGRAM

E402701E35
1.031,0.635 1.646,0.833 0.615,0.198 10 false UDO+ 1.031,1.063 1.646,1.26 0.615,0.198 10 false UDO- 1.01,1.469 1.625,1.667 0.615,0.198 10 false UJSG 1.135,1.885 1.521,2.094 0.385,0.208 10 false UPI 1.042,2.365 1.656,2.563 0.615,0.198 10 false UJSS 5.896,0.646 6.51,0.844 0.615,0.198 10 false US1+ 5.906,1.073 6.521,1.271 0.615,0.198 10 false US1- 5.896,1.49 6.51,1.688 0.615,0.198 10 false UGD1 5.906,1.885 6.521,2.083 0.615,0.198 10 false USV1 5.896,2.354 6.51,2.552 0.615,0.198 10 false USG1 2.563,3.448 5.385,3.625 2.823,0.177 10 false : Data Signal (USB Communication Line) 0.302,3.083 1.583,3.552 1.281,0.469 10 false No. 1 Stereo Jack Adapter Assembly 5.813,3.083 6.76,3.542 0.948,0.458 10 false Radio Receiver Assembly 0.313,2.896 1.563,3.094 1.25,0.198 10 false D149 1.542,0.49 2.156,0.688 0.615,0.198 10 false 3 1.563,0.938 2.177,1.135 0.615,0.198 10 false 2 1.563,1.354 2.177,1.552 0.615,0.198 10 false 4 1.552,1.76 2.167,1.958 0.615,0.198 10 false 1 1.573,2.229 2.188,2.427 0.615,0.198 10 false 5 5.833,2.927 7.083,3.125 1.25,0.198 10 false D145 5.625,0.51 5.844,0.708 0.219,0.198 10 false 3 5.625,0.917 5.844,1.115 0.219,0.198 10 false 2 5.635,1.344 5.854,1.542 0.219,0.198 10 false 4 5.635,1.76 5.854,1.958 0.219,0.198 10 false 1 5.625,2.229 5.844,2.427 0.219,0.198 10 false 5 3.531,2.333 4.781,2.531 1.25,0.198 10 false * 1.948,3.208 3.198,3.406 1.25,0.198 10 false *: Shielded

CAUTION / NOTICE / HINT

HINT:
·

When a large amount of data is in a USB device, it may take a while to begin playback.

·

When using a USB device, files that are protected by copyright cannot be played.

·

When files are not played in the sorted order, perform the following procedure before inspection.

(a)

Add numbers in front of the file names.

(b)

Put the files in a folder and copy the folder data to the USB device.


·

Check whether a USB hub is being used, and if so, remove it.

·

If there are 2 USB ports, when Apple CarPlay, Android Auto or Smart Device Link is in use, the port becomes charging-only, and cannot be used for this function.

·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION



PROCEDURE

1.CHECK USB DEVICE OR "iPod"
a.

Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.


b.

Check if playable files are present on the USB device or "iPod".

HINT:

Refer to System Description for playable files.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>SYSTEM DESCRIPTION



c.

Check if the USB device is a compatible format or "iPod" is a compatible version.

HINT:

Refer to System Description for compatible formats and versions.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>SYSTEM DESCRIPTION


Result:
Result Proceed to
No playable files exist, or incompatible device format or version. A
Playable files exist, and compatible device format or version. B




A

END (USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION IS INCOMPATIBLE, OR NO PLAYABLE FILES EXIST)

B

2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the D145 radio receiver assembly connector.


b.

Disconnect the D149 No. 1 stereo jack adapter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(D145,D149)Location & Routing

Click Connector(D145)Instrument Panel>Instrument Panel Wire>Radio Receiver Assembly

Click Connector(D149)Instrument Panel>Instrument Panel Wire>No. 1 Stereo Jack Adapter Assembly

D145-1 (USV1) - D149-1 (UPI) Always Below 1 Ω
D145-2 (US1-) - D149-2 (UDO-) Always Below 1 Ω
D145-3 (US1+) - D149-3 (UDO+) Always Below 1 Ω
D145-4 (UGD1) - D149-4 (UJSG) Always Below 1 Ω
D145-5 (USG1) - D149-5 (UJSS) Always Below 1 Ω
D145-1 (USV1) - Body ground Always 10 kΩ or higher
D145-2 (US1-) - Body ground Always 10 kΩ or higher
D145-3 (US1+) - Body ground Always 10 kΩ or higher
D145-4 (UGD1) - Body ground Always 10 kΩ or higher
D145-5 (USG1) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

3.INSPECT RADIO RECEIVER ASSEMBLY (NO. 1 STEREO JACK ADAPTER ASSEMBLY POWER SOURCE)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT RADIO RECEIVER ASSEMBLY (NO. 1 STEREO JACK ADAPTER ASSEMBLY POWER SOURCE)
a.

Disconnect the D149 No. 1 stereo jack adapter assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(D149)Location & Routing

Click Connector(D149)Instrument Panel>Instrument Panel Wire>No. 1 Stereo Jack Adapter Assembly

D149-1 (UPI) - D149-4 (UJSG) Ignition switch ACC 5 V



Result:
Proceed to
OK
NG



OK

4.FORMAT USB DEVICE OR RESTORE "iPod" AND RECHECK

NG

REPLACE RADIO RECEIVER ASSEMBLY

4.FORMAT USB DEVICE OR RESTORE "iPod" AND RECHECK
a.

Delete all files in the USB device or "iPod" and format/restore it.


b.

Save the data again and check if it can be played on the in-vehicle device.

NOTICE:

Formatting a USB device or restoring an "iPod" erases all music on the device. Ensure that a backup of the music data is available before performing this operation.


OK:

Malfunction disappears.



Result:
Proceed to
OK
NG



OK

END

NG

5.REPLACE USB DEVICE OR "iPod"
5.REPLACE USB DEVICE OR "iPod"
a.

Turn the ignition switch off.

HINT:

When this malfunction occurs, it is necessary to turn the ignition switch off to make it possible for the vehicle to recognize a new device when it is connected.



b.

Turn the ignition switch to ACC.


c.

Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

HINT:
·

If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.

·

Refer to System Description for compatible formats and versions.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>SYSTEM DESCRIPTION




Result:
Proceed to
NEXT



NEXT

6.CHECK USB DEVICE OR "iPod"
6.CHECK USB DEVICE OR "iPod"
a.

Check if a USB device or "iPod" is recognized by the radio receiver assembly, and if information such as track, artist and album names is displayed on the screen.

OK:

USB device or "iPod" is recognized properly and the information is displayed on the screen.



Result:
Proceed to
OK
NG



OK

USB DEVICE OR "iPod" WAS INCOMPATIBLE OR DEFECTIVE

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE