The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio receiver assembly via this circuit.
Disconnect the D145 radio receiver assembly connector.
Disconnect the D149 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D145,D149)Location & Routingewd_type=routing;type=c,c;code=D145,D149 Click Connector(D145)Instrument Panel>Instrument Panel Wire>Radio Receiver Assemblyewd_type=component;type=c;code=D145;pinno=2,3,5 Click Connector(D149)Instrument Panel>Instrument Panel Wire>No. 1 Stereo Jack Adapter Assemblyewd_type=component;type=c;code=D149;pinno=2,3,5 |
||
| D145-2 (US1-) - D149-2 (UD0-) | Always | Below 1 Ω |
| D145-3 (US1+) - D149-3 (UD0+) | Always | Below 1 Ω |
| D145-5 (USG1) - D149-5 (UJSS) | Always | Below 1 Ω |
| D145-2 (US1-) or D149-2 (UD0-) - Body ground | Always | 10 kΩ or higher |
| D145-3 (US1+) or D149-3 (UD0+) - Body ground | Always | 10 kΩ or higher |
| D145-5 (USG1) or D149-5 (UJSS) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG