The radio receiver assembly receives a reverse signal from the No. 2 semiconductor power integration ECU.
Move the shift lever to R and check if the back-up lights come on.
The back-up lights come on.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the D61 radio receiver assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D61)Location & Routingewd_type=routing;type=c;code=D61 Click Connector(D61)Instrument Panel>Instrument Panel Wire>Radio Receiver Assemblyewd_type=component;type=c;code=D61;pinno=28 |
||
| D61-28 (REV) - Body ground | Ignition switch ON
Shift lever in R |
11 to 14 V |
| D61-28 (REV) - Body ground | Ignition switch ON
Shift lever not in R |
Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG