Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM
RM37H0E _56 Audio / Visual / Telematics _095261 NAVIGATION / MULTI INFO DISPLAY _0453794 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Start Up Signal Circuit between Radio Receiver Assembly and Navigation ECU  


DESCRIPTION

This circuit includes the navigation ECU assembly and radio receiver assembly.

WIRING DIAGRAM

E367997E78
1.385,0.906 1.99,1.177 0.604,0.271 10 false SUP 1.76,0.781 2.365,1.052 0.604,0.271 10 false 21 5.375,0.781 5.979,1.052 0.604,0.271 10 false 7 0.521,1.823 1.125,2.094 0.604,0.271 10 false D65 0.521,1.99 2.146,2.271 1.625,0.281 10 false Navigation ECU Assembly 5.208,1.802 5.813,2.073 0.604,0.271 10 false D62 5.208,1.979 6.927,2.271 1.719,0.292 10 false Radio Receiver Assembly 5.573,0.885 6.177,1.156 0.604,0.271 10 false SUP

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NAVIGATION ECU ASSEMBLY)
a.

Disconnect the D62 radio receiver assembly connector.


b.

Disconnect the D65 navigation ECU assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(D62,D65)Location & Routing

Click Connector(D62)Instrument Panel>Instrument Panel Wire>Radio Receiver Assembly

Click Connector(D65)Instrument Panel>Instrument Panel Wire>Navigation ECU Assembly

D62-7 (SUP) - D65-21 (SUP) Always Below 1 Ω
D62-7 (SUP) or D65-21 (SUP) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR