ALL READINESS
With "All Readiness", you can use the GTS to check whether the DTC judgment has been completed.
Perform the "All Readiness" check after simulating malfunction symptoms or when performing validation after finishing repairs.
Clear the DTCs even if no DTCs are stored.
Turn the ignition switch off and wait for at least 30 seconds.
Turn the ignition switch to ON.
Perform the DTC confirmation driving pattern to run the DTC judgment.
| Tester Display |
|---|
| All Readiness |
Input the DTCs to be confirmed.
Check the DTC judgment result.
| GTS Display | Description |
|---|---|
| NORMAL | ·
DTC judgment completed ·
System normal |
| ABNORMAL | ·
DTC judgment completed ·
System abnormal |
| INCOMPLETE | ·
DTC judgment not completed ·
Perform the driving pattern after confirming DTC enabling conditions |
If the judgment result shows INCOMPLETE, perform the DTC confirmation driving pattern again.
Turn the ignition switch off.
CHECK FOR DIAGNOSIS RELATED INFORMATION
Check the diagnosis related information and freeze frame data, and then write them down.
| Tester Display |
|---|
| Diagnosis Related Information |
CLEAR DIAGNOSIS RELATED INFORMATION
Clearing the DTCs will also clear the diagnosis related information.
Clear the diagnosis related information and freeze frame data.