Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM37H0E _55 Steering _097126 POWER ASSIST SYSTEMS _0454879 POWER STEERING SYSTEM D

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  VEHICLE CONTROL HISTORY  


DESCRIPTION


·

Vehicle Control History is a function that captures and stores ECU data when triggered by specific vehicle behavior.

·

It may be possible to determine the cause of the malfunction by checking the vehicle history information and freeze frame data.

·

The number of possible stored Freeze Frame Data sets, whether multi Freeze Frame Data is available, the number of freeze frame points, Freeze Frame Data items, the ECU internal range, etc., is different depending on the stored group.

·

The stored data items for Vehicle Control History Freeze Frame Data are different depending on the stored group. When the value of a data item does not change across all points, only the value of the detection point will be displayed. The content of the Freeze Frame Data is almost the same as that of the Data List.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DATA LIST / ACTIVE TEST



PRECAUTIONS


·

As Vehicle Control History may be overwritten whenever the trigger conditions are met, make sure to save Vehicle Control History before performing any inspections.

·

As Vehicle Control History may be stored when performing an Active Test, learning, etc., make sure to clear the Vehicle Control History before returning the vehicle to the customer.



CHECK VEHICLE CONTROL HISTORY


a.

Using the GTS, check the vehicle control history (RoB).

Chassis > EMPS > Utility
Tester Display
Vehicle Control History (RoB)
50005 405 55
FFD Group Code Tester Display Measurement Item EPS Warning Light Diagnostic Note
- X200C Vehicle Speed Signal Invalidity
·

Record of vehicle speed signal invalid history updates

·

Record of vehicle speed signal invalid history updates (only when CAN vehicle speed (SP1) is disabled)


Yellow illuminated -
- X206D Power Source Stop Record of engine stall/shutdown control history updates Yellow illuminated -
- X206E High Load Continuation Record of high load continuous control history updates Does not come on -
- X206F Prevention of ECU/Motor Overheat Record of overheat prevention control history updates Does not come on -
- X208F Battery Voltage Drop Record of power source voltage drop control history updates Red illuminated -
·

Record of power source voltage drop suppression control history updates

·

Record of low battery voltage history updates


Yellow illuminated -
·

Record of load control history updates

·

Record of chassis power management EPS control history updates


Does not come on -
- X210A Battery Voltage Drop (System 2) Record of power source voltage drop control history updates Red illuminated -
·

Record of power source voltage drop suppression control history updates

·

Record of auxiliary battery voltage drop history updates


Yellow illuminated -
- X2147 Vehicle Speed Signal Invalidity (System 2)
·

Record of vehicle speed signal invalid history updates

·

Record of vehicle speed signal invalid history updates (only when CAN vehicle speed (SP1) is disabled)


Yellow illuminated -
- X2148 Power Source Stop (System 2) Record of engine stall/READY OFF control history updates Yellow illuminated -
- X2149 High Load Continuation (System 2) Record of high load continuous control history updates Does not come on -
- X214A Prevention of ECU/Motor Overheat (System 2) Record of overheat prevention control history updates Does not come on -
- X214C Battery Voltage High Record of when power source overvoltage occurs Does not come on -
- X214D Battery Voltage High (System 2) Record of when power source overvoltage occurs Does not come on -
- X2600 Software Incompatibility with ENG/HV Control Module (Not Programmed) When gasoline model or HV model information has not been written Red illuminated -
- X2601 Software Inconsistency with ENG/HV Control Module
·

Record of when assist map has not been written

·

Record of when assist map identification malfunction is detected

·

Record of when gasoline model or HV model identification malfunction is detected


Does not come on -
- X2603 Software Inconsistency with Body Control Module
·

Record of when assist map has not been written

·

Record of when assist map identification malfunction is detected


Does not come on -
- X2605 Software Inconsistency with Brake Control Module
·

Record of when assist map has not been written

·

Record of when assist map identification malfunction is detected


Does not come on -
- X2606 Software Inconsistency with Suspension Control Module
·

Record of when assist map has not been written

·

Record of when assist map identification malfunction is detected


Does not come on -
- X2608 Software Incompatibility with VGRS Control Module (Not Programmed) Record of when assist map has not been written Red illuminated -
- X2609 Software Inconsistency with VGRS Control Module Record of when assist map identification malfunction is detected Does not come on -
- X260A Software Incompatibility with DRS Control Module (Not Programmed) Record of when assist map has not been written Red illuminated -
- X260B Software Inconsistency with DRS Control Module Record of when assist map identification malfunction is detected Does not come on -
- X260D Software Inconsistency with Steering Angle Sensor Module Record of when assist map identification malfunction is detected Does not come on -
- X2612 Assist Map Non-Memory Record of when assist map has not been written Red illuminated -
- X262C Torque Sensor "A" Missing Calibration of Adjustment Value Non-Memory Record of when zero point calibration of the torque sensor is not performed Red illuminated -
- X262D Torque Sensor "A" Missing Calibration of Adjustment Incomplete Record of when zero point calibration of the torque sensor is incomplete Red illuminated -
- X262E Torque Sensor "B" Missing Calibration of Adjustment Value Non-Memory Record of when zero point calibration of the torque sensor is not performed Red illuminated -
- X262F Torque Sensor "B" Missing Calibration of Adjustment Incomplete Record of when zero point calibration of the torque sensor is incomplete Red illuminated -
- X2630 Software Inconsistency with Steering Angle Sensor Module (System 2) Record of when assist map identification malfunction is detected Does not come on -
- X2631 Software Inconsistency with Body Control Module (System 2)
·

Record of when assist map has not been written

·

Record of when assist map identification malfunction is detected


Does not come on -
- X2632 Software Inconsistency with Brake Control Module (System 2)
·

Record of when assist map has not been written

·

Record of when assist map identification malfunction is detected


Does not come on -
- X2633 Software Inconsistency with Suspension Control Module (System 2)
·

Record of when assist map has not been written

·

Record of when assist map identification malfunction is detected


Does not come on -
- X2634 Software Incompatibility with VGRS Control Module (Not Programmed) (System 2) Record of when assist map has not been written Red illuminated -
- X2635 Software Inconsistency with VGRS Control Module (System 2) Record of when assist map identification malfunction is detected Does not come on -
- X2636 Software Incompatibility with DRS Control Module (Not Programmed) (System 2) Record of when assist map has not been written Red illuminated -
- X2637 Software Inconsistency with DRS Control Module (System 2) Record of when assist map identification malfunction is detected Does not come on -
- X2638 Software Incompatibility with ENG/HV Control Module (Not Programmed) (System 2) When gasoline/HV model information has not been written Red illuminated -
- X2639 Software Inconsistency with ENG/HV Control Module (System 2)
·

Record of when assist map has not been written

·

Record of when assist map identification malfunction is detected

·

Record of when gasoline/HV model identification malfunction is detected


Does not come on -
- X2640 Assist Map Non-Memory (System 2) Record of when assist map has not been written Red illuminated -
- X2848 Steering Take Over (Strong Steering Torque Input) Record of when a strong steering torque input judgment is confirmed during advanced drive control Does not come on -
- XF01B ECU Security Key Not Registered ECU security key has not been updated Does not come on (Click here)



CLEAR VEHICLE CONTROL HISTORY


a.

Using the GTS, display the vehicle control history (RoB).

Chassis > EMPS > Utility
Tester Display
Vehicle Control History (RoB)
50005 405 55

b.

Select the clear button and follow the instructions on the screen to clear the vehicle control history.

NOTICE:

When the vehicle control history is cleared, all the stored history items are cleared.