Home › Steering › STEERING COLUMN › HEATED STEERING WHEEL SYSTEM
RM37H0E _55 Steering _095770 STEERING COLUMN _0454880 HEATED STEERING WHEEL SYSTEM U

STEERING COLUMN  HEATED STEERING WHEEL SYSTEM  TERMINALS OF ECU  


STEERING VIBRATION ECU


HINT:

Perform the inspection from the harness side with the connectors connected.


C453477E02
4.552,0.167 4.969,0.385 0.417,0.219 2.365,0.177 2.76,0.385 0.396,0.208 4.74,0.229 4.896,0.427 0.156,0.198 10 false A 2.542,0.219 2.698,0.417 0.156,0.198 10 false B

a.

Measure the voltage or resistance according to the value(s) in the table below.

Terminal No. (Symbol) Terminal Description Condition Specified Condition
A-1 (GND) - Body ground Ground Always Below 1 Ω
A-3 (LIN) - Body ground LIN communication signal Ignition switch ON Pulse generation
A-4 (IG) - Body ground IG power supply Ignition switch ON 11 to 14 V
B-1 (SH1) - Body ground Heater output signal Ignition switch ON, Heated steering wheel system operating Below 1 V
B-2 (TH1) - Body ground Thermistor input signal Ignition switch ON, Heated steering wheel system operating 11 to 14 V*1
B-3 (TH2) - Body ground Thermistor ground Ignition switch ON, Heated steering wheel system operating 2.5 to 4.8 V*2
B-4 (SH3) - Body ground Heater ground Ignition switch ON, Heated steering wheel system operating Below 1 V
B-5 (SH2) - Body ground Heater ground Ignition switch ON, Heated steering wheel system operating Below 1 V

HINT:
·

*1: The current to the heater turns ON/OFF depending on the temperature of the thermistor. As a result, it may take several minutes before a voltage value is output.

·

*2: When ambient temperature is 0 to 40°C (32 to 104°F).