Home › Vehicle Interior › POWER OUTLETS (INT) › WIRELESS CHARGING SYSTEM
RM37H0E _58 Vehicle Interior _094007 POWER OUTLETS (INT) _0454981 WIRELESS CHARGING SYSTEM U

POWER OUTLETS (INT)  WIRELESS CHARGING SYSTEM  TERMINALS OF ECU  


CHECK MOBILE WIRELESS CHARGER CRADLE ASSEMBLY


E216115N30
3.375,0.167 3.896,0.417 0.521,0.25 3.5,0.208 3.844,0.375 0.344,0.167 10 false D103

Terminal No. (Symbol) Terminal Description Condition Specified Condition

*1: When the ignition switch is turned from off to ACC, the mobile wireless charger cradle assembly monitors the charging suspension signal for 5 seconds. If the charging suspension signal is not 4 V or more for 0.8 seconds or more during monitoring, the mobile wireless charger cradle assembly determines that there is an open in the charging suspension signal line, blinks (pattern 1) the indicator light (amber), and prohibits operation until the ignition switch is turned from off to ACC again.

Click here(Click here)

*2: For details about conditions when the certification ECU (smart key ECU assembly) sends the charging suspension signal, refer to System Description.

Click here(Click here)

D103-1 (PGND) - Body ground Ground Always Below 1 V
D103-5 (ACC) - D103-1 (PGND) Power source (ACC) Ignition switch ACC 11 to 14 V
Ignition switch off Below 1 V
D103-6 (B+) - D103-1 (PGND) Power source (+B) Ignition switch off 11 to 14 V
D103-7 (DIS) - Body ground Charging suspension signal For 5 seconds after turning ignition switch from off to ACC*1 4.5 to 6.0 V
Device being charged Below 1 V
Charging suspended due to the smart key system status*2 4.5 to 6.0 V
D103-10 (TAIL) - Body ground Taillight signal Ignition switch ON, light control switch off Below 1 V
Ignition switch ON, light control switch TAIL 11 to 14 V