This is the power source circuit for the mobile wireless charger cradle assembly.
Inspect the fuses for circuits related to this system before performing the following procedure.
Disconnect the D103 mobile wireless charger cradle assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D103)Location & Routingewd_type=routing;type=c;code=D103 Click Connector(D103)Instrument Panel>Instrument Panel Wire>Mobile Wireless Charger Cradle Assemblyewd_type=component;type=c;code=D103;pinno=1 |
||
| D103-1 (PGND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D103)Location & Routingewd_type=routing;type=c;code=D103 Click Connector(D103)Instrument Panel>Instrument Panel Wire>Mobile Wireless Charger Cradle Assemblyewd_type=component;type=c;code=D103;pinno=6,5 |
||
| D103-6 (B+) - Body ground | Ignition switch off | 11 to 14 V |
| D103-5 (ACC) - Body ground | Ignition switch ACC | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG