Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM
RM37H0E _58 Vehicle Interior _095300 HEATING / AIR CONDITIONING _0455055 AIR CONDITIONING SYSTEM D

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  CHECK MODE PROCEDURE  


REFRIGERANT SHORTAGE CHECK USING GTS


a.

Enter the following menus: Body Electrical / Air Conditioner / Utility / Refrigerant Gas Volume Check.

Body Electrical > Air Conditioner > Utility
Tester Display
Refrigerant Gas Volume Check
50005 121 2186

b.

According to the display on the GTS, perform the refrigerant shortage check when the following conditions are met.

Measurement Condition:
Item Condition
A/C switch On
Ambient temperature*2 0 to 49°C (32 to 120°F)
Air conditioning inlet temperature*3 25 to 49°C (77 to 120°F)
Setting temperature MAX COLD
Blower damper position Recirculation
Outlet damper position FACE
Blower speed HI

*2: If the ambient temperature is not within the range shown, do not perform this check.

*3: The air inlet temperature can be judged correctly only if it is within an appropriate range of 25 to 79°C (77 to 174°F). Therefore, use the heater mode to adjust the temperature so that it falls within the appropriate range and then perform the check.


HINT:
·

Refer to the GTS operator's manual for further details.

·

A message indicating a refrigerant shortage is displayed on the GTS and the air conditioning system turns off if the amount of refrigerant in the system is insufficient.

·

DTCs are not stored when performing the refrigerant shortage check using the GTS.



Result:
Result Amount of Refrigerant Corrective Action
Refrigerant shortage Insufficient or leakage
1.

Check for refrigerant leaks using a halogen leak detector, and repair if necessary.

2.

Evacuate the air conditioning system and charge it with the appropriate volume of new or purified refrigerant.

for HFC-134a (R134a):(Click here)

for HFO-1234yf (R1234yf):(Click here)



Refrigerant correct Correct -