The air conditioning harness assembly connects the air conditioning amplifier assembly and the servo motors. The air conditioning amplifier assembly supplies power and sends operation instructions to each servo motor through the air conditioning harness assembly. Each servo motor sends damper position information to the air conditioning amplifier assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | DTC Output from | Priority |
|---|---|---|---|---|---|---|
| B1497 | Communication Malfunction (Bus Ic) | ·
Diagnosis condition: None ·
Malfunction status: Error or open in communication line between air conditioning amplifier assembly and servo motor |
·
Air conditioning harness assembly ·
No. 1 air conditioning radiator damper servo sub-assembly ·
No. 2 air conditioning radiator damper servo sub-assembly ·
No. 3 air conditioning radiator damper servo sub-assembly ·
No. 4 air conditioning radiator damper servo sub-assembly ·
No. 5 air conditioning radiator damper servo sub-assembly ·
No. 6 air conditioning radiator damper servo sub-assembly (for 3 Zone) ·
No. 1 blower damper servo sub-assembly ·
Air conditioning amplifier assembly |
Memorized | Air Conditioner | A |
for LHD:
for RHD:
Check the operation by referring to the table below.
| Tester Display | Measurement Item | Control Range | Restrict Condition |
|---|---|---|---|
| Air Mix Servo Targ Pulse(D) | for LHD:
No. 2 air conditioning radiator damper servo sub-assembly (driver side lower air mix) operation for RHD:
No. 1 air conditioning radiator damper servo sub-assembly (driver side lower air mix) operation |
Min.: 128
Max.: 383 |
for LHD (for Dual):
Operates between 154 to 258 pulses for LHD (for 3 Zone):
Operates between 254 to 358 pulses for RHD:
Operates between 154 to 258 pulses |
| Air Mix Servo Targ Pulse(P) | for LHD:
No. 3 air conditioning radiator damper servo sub-assembly (front passenger side lower air mix) operation for RHD:
No. 2 air conditioning radiator damper servo sub-assembly (front passenger side lower air mix) operation |
Min.: 128
Max.: 383 |
for LHD:
Operates between 154 to 258 pulses for RHD (for Dual):
Operates between 154 to 258 pulses for RHD (for 3 Zone):
Operates between 254 to 358 pulses |
| Air Inlet Damper Targ Pulse | No. 1 blower damper servo sub-assembly operation | Min.: 128
Max.: 383 |
for LHD:
Operates between 258 to 290 pulses for RHD:
Operates between 222 to 254 pulses |
| Cool A/M Servo Pulse(D) | for LHD:
No. 2 air conditioning radiator damper servo sub-assembly (driver side upper air mix) operation for RHD:
No. 14 air conditioning radiator damper servo sub-assembly (driver side upper air mix) operation |
Min.: 128
Max.: 383 |
for LHD:
Operates between 254 and 326 pulses for RHD:
Operates between 186 to 258 pulses |
| Cool A/M Servo Pulse(P) | for LHD:
No. 3 air conditioning radiator damper servo sub-assembly (front passenger side upper air mix) operation for RHD:
No. 2 air conditioning radiator damper servo sub-assembly (front passenger side upper air mix) operation |
Min.: 128
Max.: 383 |
for LHD:
Operates between 186 and 258 pulses for RHD:
Operates between 254 to 326 pulses |
| Face A/O Servo Pulse(D) | for LHD:
No. 1 air conditioning radiator damper servo sub-assembly (MODE FACE (for Dual)), (driver side MODE FACE (for 3 Zone)) operation for RHD:
No. 3 air conditioning radiator damper servo sub-assembly (MODE FACE (for Dual)), (driver side MODE FACE (for 3 Zone)) operation |
Min.: 128
Max.: 383 |
for LHD:
Operates between 258 and 364 pulses for RHD:
Operates between 148 to 254 pulses |
| Foot A/O Servo Pulse(D) | for LHD:
No. 1 air conditioning radiator damper servo sub-assembly (MODE FOOT (for Dual)), (Driver side MODE FOOT (for 3 Zone)) operation for RHD:
No. 3 air conditioning radiator damper servo sub-assembly (MODE FOOT (for Dual)), (Driver side MODE FOOT (for 3 Zone)) operation |
Min.: 128
Max.: 383 |
for LHD:
Operates between 258 and 365 pulses for RHD:
Operates between 147 to 254 pulses |
| Face A/O Servo Pulse(P) | No. 6 air conditioning radiator damper servo sub-assembly (front passenger side MODE FACE) operation | Min.: 128
Max.: 383 |
for LHD:
Operates between 147 and 254 pulses for RHD:
Operates between 258 and 364 pulses (for 3 Zone) |
| Foot A/O Servo Pulse(P) | No. 6 air conditioning radiator damper servo sub-assembly (front passenger side MODE FOOT) operation | Min.: 128
Max.: 383 |
for LHD:
Operates between 148 and 254 pulses for RHD:
Operates between 258 and 365 pulses (for 3 Zone) |
| A/M Servo Pulse(F&R D) | No. 2 air conditioning radiator damper servo sub-assembly (air mix (rear)) operation | Min.: 128
Max.: 383 |
Operates between 154 and 258 pulses |
| A/O Servo Pulse(F&R D) | for LHD:
No. 4 air conditioning radiator damper servo sub-assembly (MODE FACE/FOOT (rear)) operation for RHD:
No. 5 air conditioning radiator damper servo sub-assembly (MODE FACE/FOOT (rear)) operation |
Min.: 128
Max.: 383 |
for LHD:
Operates between 249 and 289 pulses for RHD:
Operates between 263 and 289 pulses (for 3 Zone) |
| DEF A/O Servo Pulse(D) | for LHD:
No. 5 air conditioning radiator damper servo sub-assembly (MODE DEF) operation for RHD:
No. 4 air conditioning radiator damper servo sub-assembly (MODE DEF) operation |
Min.: 128
Max.: 383 |
for LHD:
Operates between 249 and 289 pulses for RHD:
Operates between 263 and 289 pulses (for 3 Zone) |
| Tester Display |
|---|
| Air Mix Servo Targ Pulse(D) |
| Tester Display |
|---|
| Air Mix Servo Targ Pulse(P) |
| Tester Display |
|---|
| Air Inlet Damper Targ Pulse |
| Tester Display |
|---|
| Cool A/M Servo Pulse(D) |
| Tester Display |
|---|
| Cool A/M Servo Pulse(P) |
| Tester Display |
|---|
| Face A/O Servo Pulse(D) |
| Tester Display |
|---|
| Foot A/O Servo Pulse(D) |
| Tester Display |
|---|
| Face A/O Servo Pulse(P) |
| Tester Display |
|---|
| Foot A/O Servo Pulse(P) |
| Tester Display |
|---|
| A/M Servo Pulse(F&R D) |
| Tester Display |
|---|
| A/O Servo Pulse(F&R D) |
| Tester Display |
|---|
| DEF A/O Servo Pulse(D) |
Damper servo motor is operated.
| Result | Proceed to |
|---|---|
| All damper servo motors are not operated | A |
| Any damper servo motor is not operated | B |
| All damper servo motors are operated | C |
A
B
C
Pre-procedure1
| *a | Component without harness connected
(Air Conditioning Amplifier Assembly) |
Disconnect the z1 air conditioning amplifier assembly connector.
Procedure1
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 (BUS G) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG
Pre-procedure1
| *a | Component without harness connected
(Air Conditioning Amplifier Assembly) |
Disconnect the z1 air conditioning amplifier assembly connector.
Procedure1
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 4 (B BUS) - 2 (BUS G) | Ignition switch off | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG
Pre-procedure1
| *a | Component without harness connected
(Air Conditioning Amplifier Assembly) |
Disconnect the z1 air conditioning amplifier assembly connector.
Procedure1
Using an oscilloscope, check the waveform.
| Tester Connection | Tool Setting | Condition |
|---|---|---|
| 3 (BUS) - 2 (BUS G) | 2 V/DIV., 20 μs/DIV. | Ignition switch ON |
The waveform displays properly.
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG