PRECAUTION FOR REPLACING COMBINATION METER ASSEMBLY
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
SENSOR EXPRESSIONS
The descriptions for the blind spot monitor sensors differ depending on the system. The expressions listed in the table below are used in this Repair Manual.
| Part Name | Actual Part Name |
|---|---|
| Blind spot monitor sensor RH (B) | Blind spot monitor sensor RH |
| Blind spot monitor sensor LH (A) | Blind spot monitor sensor LH |