Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM
RM37H0E _58 Vehicle Interior _095316 METER / GAUGE / DISPLAY _0455143 METER / GAUGE SYSTEM D

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  OPERATION CHECK  


INSPECT COMBINATION METER ASSEMBLY


a.

Check speedometer operation

NOTICE:
·

The combination meter assembly receives the vehicle speed signal from the skid control ECU assembly via CAN communication. Therefore, perform the following inspection referring to values on the Data List of the skid control ECU assembly because it is the source of the vehicle speed signal.

·

Data List values of the skid control ECU assembly are used for this inspection. Therefore, make sure to perform this inspection after confirming that DTCs are not output.



i.

Read the Data List according to the display on the GTS.

Chassis > Brake/EPB > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Vehicle Speed Vehicle speed
(Vehicle speed signal output to combination meter assembly)
Min.: 0.0 km/h (0 mph), Max.: 6553.5 km/h (4072 mph) Vehicle stopped: 0.0 km/h (0 mph) When driving at constant speed: No large fluctuations
Chassis > Brake/EPB > Data List
Tester Display
Vehicle Speed
50003 435 36
Reference mph
GTS Indication (mph) Acceptable Range (mph)
20 19.5 to 22.0
40 39.9 to 42.9
60 60.8 to 63.6
80 81.3 to 84.5
100 102.1 to 105.3
120 122.8 to 126.0

Reference km/h
GTS Indication (km/h) Acceptable Range (km/h)
20 20.8 to 22.8
40 41.6 to 43.6
60 62.3 to 64.3
80 83.1 to 85.1
100 103.9 to 105.9
120 124.7 to 126.7
140 145.4 to 147.4
160 166.2 to 168.2
180 187.0 to 189.0

OK:

Speedometer reading is within the acceptable range at each vehicle speed.




b.

Check LED illumination (LED check)

i.

Check the illumination function of the warning or indicator lights listed below when turning the ignition switch ON.

Indicator/Warning Light Switch Condition Specified Condition
Brake warning light Ignition switch off → ON Comes on for 3 seconds
Master warning light
ABS warning light
Slip indicator light
VSC OFF indicator light
PCS OFF warning light
RCTA OFF indicator light
Brake hold standby indicator light
Brake hold operated indicator light
Tire pressure warning light
SRS warning light Ignition switch off → ON Comes on for 6 seconds
Pop up hood warning light
EPS warning light Ignition switch off → ON
·

Illuminates when ignition switch is turned to ON

·

Turns off when engine started


MIL (Malfunction indicator lamp)