COMBINATION METER ASSEMBLY
Disconnect the combination meter assembly connectors.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| D41-21 (IG+) - Body ground | Ignition switch signal | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V | ||
| D41-22 (B) - Body ground | Auxiliary battery | Ignition switch off | 11 to 14 V |
| D42-1 (B) - Body ground | Auxiliary battery | Ignition switch off | 11 to 14 V |
| D41-39 (ILL-) - Body ground | Illumination signal | Headlight dimmer switch off | Below 1 V |
| Headlight dimmer switch in tail or head position | 11 to 14 V | ||
| D41-38 (IL2-) - Body ground | Illumination signal | Headlight dimmer switch off | Below 1 V |
| Headlight dimmer switch in tail or head position | 11 to 14 V | ||
| D41-40 (EP) - Body ground | Ground | Always | Below 1 Ω |
Reconnect the combination meter assembly connectors.
Measure the voltage and resistance and check for pulses according to the value(s) in the table below.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
|
*: w/o All Auto Control |
|||
| D41-2 (MSM+) - Body ground | Steering pad switch signal | Ignition switch ON, enter, trip and back switches on steering pad switch not pushed | 4.3 to 5.2 V |
| Ignition switch ON, enter switch on steering pad switch pushed | Below 0.6 V | ||
| Ignition switch ON, trip switch on steering pad switch pushed | 1.0 to 2.2 V | ||
| Ignition switch ON, back switch on steering pad switch pushed | 2.3 to 3.4 V | ||
| D41-3 (MSTI) - Body ground | Steering pad switch signal | Ignition switch ON, up, down, right and left switches on steering pad switch assembly not pushed | 4.3 to 5.2 V |
| Ignition switch ON, left switch on steering pad switch pushed | Below 0.6 V | ||
| Ignition switch ON, up switch on steering pad switch pushed | 1.0 to 2.2 V | ||
| Ignition switch ON, down switch on steering pad switch pushed | 2.3 to 3.4 V | ||
| Ignition switch ON, right switch on steering pad switch pushed | 3.4 to 4.5 V | ||
| D41-4 (ODO) - Body ground | ODO/TRIP switch signal | Ignition switch ON, ODO/TRIP switch not pushed | 4 to 6 V |
| Ignition switch ON, ODO/TRIP switch pushed | Below 1 V | ||
| D41-6 (PODS) - Body ground | Occupant detection sensor signal | Front passenger seat occupaied | Below 100 Ω |
| Front passenger seat not occupaied | 1 MΩ or higher | ||
| D41-7 (TX-) | Local bus communication line | - | - |
| D41-8 (TX+) | Local bus communication line | - | - |
| D41-12 (RRSB) - Body ground | Rear RH seat belt buckle switch signal | Ignition switch ON, Rear RH seat belt fastened. | 11 to 14 V |
| Ignition switch ON, Rear RH seat belt unfastened. | Below 1 V | ||
| D41-13 (RCSB) - Body ground | Rear center seat belt buckle switch signal | Ignition switch ON, Rear center seat belt fastened. | 11 to 14 V |
| Ignition switch ON, Rear center seat belt unfastened. | Below 1 V | ||
| D41-14 (RLSB) - Body ground | Rear LH seat belt buckle switch signal | Ignition switch ON, Rear LH seat belt fastened. | 11 to 14 V |
| Ignition switch ON, Rear LH seat belt unfastened. | Below 1 V | ||
| D41-18 (PBKL) - Body ground* | Front passenger seat belt buckle switch signal | Front passenger seat belt fastened | 10 kΩ or higher |
| Front passenger seat belt unfastened | Below 1 Ω | ||
| D41-19 (+S) - Body ground | Speed signal for other system | Ignition switch ON, wheel being rotated | Pulse generation (See waveform 1) |
| D41-20 (SI) - Body ground | Speed signal for other system | Ignition switch ON, wheel being rotated | Pulse generation (See waveform 1) |
| D41-25 (TR) - Body ground | Light control rheostat switch signal | Ignition switch ON, up switch and down switch of trip switch not pushed | 4 to 6 V |
| Ignition switch ON, up switch or down switch of trip switch pushed | Below 1 V | ||
| D41-26 (SW3) - Body ground | Ground for trip switch | Always | Below 1 Ω |
| D41-29 (CANH) | CAN communication line | - | - |
| D41-30 (CANL) | CAN communication line | - | - |
| D41-31 (ES) - Body ground | Ground | Always | Below 1 Ω |
| D42-2 (HAZ) - Body ground | Hazard warning signal switch signal | Hazard warning signal switch off | 11 to 14 V |
| Hazard warning signal switch on | Below 1 V | ||
| D42-5 (TRNR) - Body ground | Rear turn signal light RH signal | Ignition switch ON, RH turn indicator light off | Below 1 V |
| Ignition switch ON, RH turn indicator light blinking | 11 to 14 V ←→ Below 1 V | ||
| D42-6 (INT) - Body ground | Tire pressure warning light signal | Ignition switch ON, tire pressure warning light off | Below 1 V |
| Ignition switch ON, tire pressure warning light on | 11 to 14 V | ||
| D42-7 (LR) - Body ground | Front/Side turn signal light RH signal | Ignition switch ON, RH turn indicator light off | Below 1 V |
| Ignition switch ON, RH turn indicator light blinking | 11 to 14 V ←→ Below 1 V | ||
| D42-11 (TRNL) - Body ground | Rear turn signal light LH signal | Ignition switch ON, LH turn indicator light off | Below 1 V |
| Ignition switch ON, LH turn indicator light blinking | 11 to 14 V ←→ Below 1 V | ||
| D42-13 (LL) - Body ground | Front/Side turn signal light LH signal | Ignition switch ON, LH turn indicator light off | Below 1 V |
| Ignition switch ON, LH turn indicator light blinking | 11 to 14 V ←→ Below 1 V | ||
If the result is not as specified, the combination meter assembly may be malfunctioning.
Waveform 1 (Reference):
| Item | Condition |
|---|---|
| Tester Connection | ·
D41-20 (SI) - Body ground ·
D41-19 (+S) - Body ground |
| Tool Setting | 5 V/DIV., 20 ms./DIV. |
| Vehicle Condition | Ignition switch ON, wheel being rotated |
When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.