HEADUP DISPLAY (METER MIRROR SUB-ASSEMBLY)
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| D95-1(IG) - Body ground | Ignition switch signal | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V | ||
| D95-2(B) - Body ground | Auxiliary battery | Ignition switch off | 11 to 14 V |
| D95-4(ES) - Body ground | Ground | Always | Below 1 Ω |
| D95-9(SW1) - Body ground | Trip switch (headup display switch) signal | Ignition switch ON, trip switch (headup display switch) not pushed | 4 to 6 V |
| Ignition switch ON, trip switch (headup display switch) pushed | Below 1 V | ||
| D95-12(MPX1) | CAN communication line | - | - |
| D95-13(MPX2) | CAN communication line | - | - |
| D95-14(TX+) | Local bus communication line | - | - |
| D95-15(TX-) | Local bus communication line | - | - |
| D95-16(E) - Body ground | Ground | Always | Below 1 Ω |