CASES OF UNNECESSARY PARKING SUPPORT BRAKE SYSTEM (STATIC OBJECTS)
In the following situations, the parking support brake system may operate even when there is no possibility of a collision:
Environmental influence
There is an obstacle on the shoulder of the road (when the vehicle is driven in a narrow tunnel, on a narrow bridge or on a narrow road).
The vehicle is being driven on grass or a gravel road.
The vehicle is driven toward a banner or flag, a low-hanging branch or a boom barrier (such as those used at railroad crossings, toll gates and parking lots).
Even if the parking support brake system operates while on a railroad crossing, brake control will be automatically be canceled after approximately 2 seconds. Brake control can also be canceled by depressing the brake pedal. After brake control is canceled, depress the accelerator pedal to drive out of the railroad crossing.
The vehicle is close to other vehicles while being parallel parked.
The vehicle is being driven on a steep slope.
There are objects located lower than the ultrasonic sensors.
The vehicle is being driven on a narrow road.
There is a rut or hole in the surface of the road.
When the vehicle is driven on a metal cover (grating), such as those used for drainage ditches.
Influence from the weather
In severe weather such as fog, snow or a sandstorm.
Foreign matter such as snow, ice or mud is attached to an ultrasonic sensor. (The system returns to normal when the foreign matter is removed.)
When there is a downpour, or water is splashing on the vehicle.
Water is covering an ultrasonic sensor due to a flooded road.
Influence from other ultrasonic waves
When ultrasonic waves are received from the horn or parking sonar system of another vehicle, a motorcycle engine, or the air brakes of a large vehicle.
Electronic components such as a backlit license plate (especially fluorescent types), fog lights, a fender pole or a wireless antenna are installed near an ultrasonic sensor.
Changes in the vehicle.
The height of the vehicle has drastically changed due to loading (the nose tilts up or down).
The vehicle is significantly tilted.
An ultrasonic sensor is misaligned due to a collision, etc.
Others
The vehicle is being loaded onto a ship, truck or other transport vessel.
The vehicle is being operated on a drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer.
When the vehicle is being towed.
CASES OF UNNECESSARY PARKING SUPPORT BRAKE SYSTEM (REAR CROSSING VEHICLES)
In the following situations, the rear crossing traffic auto brake function may operate even when there is no possibility of a collision:
When a vehicle is travelling along a road that is located extremely close to a parking space.
When a vehicle is entering an adjacent parking space.
When an object is passing extremely close to the vehicle.
When there is a metal object behind the vehicle such as a guard rail, wall, traffic sign or parked vehicle that easily reflects radio waves.
CASES OF UNNECESSARY PARKING SUPPORT BRAKE SYSTEM (REAR PEDESTRIANS)
Situations in which pedestrians cannot be detected normally.
Solid objects (pillars, pylons, fences, parked vehicles, etc.)
Moving objects (such as passing vehicles, motorcycles, etc.)
Moving objects (such as flags, exhaust gas, large drops of rain, large snowflakes, rainwater on roads, etc.)
Patterns on roads (white lines, pedestrian crossings, stones, streetcar rails, repaired areas, fallen leaves, gravel, etc.)
Surrounding objects reflected off puddles or wet road surfaces.
Shadows.
Driving onto an area with a difference in height.
Grating, ditches and gutters.
Sides of roads and steps.
The vehicle is extremely tilted (loaded, suddenly braking, etc.).
A lowered suspension or tire with a different diameter than a genuine tire, etc. is installed.
There are changes in gradient.
The camera is dirty (dirty, snow-melting agents, etc.).
Water drops are moving over the camera lens.
Others
An aftermarket accessory (backlit license plate, fog light, etc.) is installed near the rear camera.
An aftermarket protective part is installed to the rear bumper (bumper trim, etc.).
The axis of the camera is misaligned (due to reinstallation, collision, etc.).
A towing hook is installed.
MULTI-INFORMATION DISPLAY AND HEADUP DISPLAY (w/ Headup Display System)
parking support brake system display
The parking support brake system uses the multi-information display in the combination meter assembly, multi-display assembly, the meter mirror sub-assembly and PKSB OFF indicator light to indicate the operation status of the system.
parking support brake system operation status display
When the operation conditions are met, the clearance warning ECU assembly sends display or illumination request signals to the combination meter assembly, multi-display assembly, meter mirror sub-assembly and PKSB OFF indicator light. The clearance warning ECU assembly also sends buzzer sound request signals to the combination meter assembly.
| Situation | Multi-information Display | Multi-display | Headup Display*3 | PKSB OFF Indicator Light | Meter Buzzer |
|---|---|---|---|---|---|
|
*1: May be displayed if snow or other foreign matter is attached to an ultrasonic sensor. *2: Brake pedal is not depressed *3: w/ Headup Display System |
|||||
| Driving torque restriction control is being performed (acceleration restricted) | Object Detected Acceleration Reduced*1,*2 | Not displayed | Not displayed | Not illuminated | Does not sound |
| Maximum driving torque restriction control is being performed (strong braking is required) | BRAKE ! *2 | BRAKE ! | BRAKE ! | Sounds once | |
| Brake control is being performed (Emergency braking is required) | BRAKE ! *2 | BRAKE ! | BRAKE ! | ||
| Vehicle is stopped after brake control has been performed | Release Accelerator and Depress Brake | Not displayed | Switch to Brake | Illuminates | |
| Parking support brake system is off | Not displayed | Not displayed | Not displayed | Does not sound | |
parking support brake system warning display
When operation of the parking support brake system is temporarily suspended due to a malfunction or dirty ultrasonic sensor, a message is displayed on the multi-information display in the combination meter assembly, the PKSB OFF indicator light illuminates and the buzzer sounds.
| Situation | Multi-information Display | PKSB OFF Indicator Light | Meter Buzzer |
|---|---|---|---|
|
*1: Including when the shift lever is not in D or R. *2: Only displayed when the ignition switch is turned ON. |
|||
| The parking support brake system is malfunctioning | Parking Support Brake Malfunction Visit Your Dealer | Illuminates | Sounds |
| The parking support brake system is temporarily suspended (due to a dirty ultrasonic sensor, etc.)*1 | Parking Support Brake Unavailable *2 | Does not sound | |
| Parking Support Brake Unavailable Remove the Dirt of Rear Camera | |||
| *a | PKSB OFF Indicator |
parking support brake system off display
When the parking support brake system is off, the PKSB OFF indicator light illuminates.