Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM
RM37H0E _56 Audio / Visual / Telematics _095293 PARK ASSIST / MONITORING _0455113 PARKING ASSIST MONITOR SYSTEM C

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM  U0126  Lost Communication with Steering Angle Sensor Module  U0140  Lost Communication with Body Control Module  U0163  Lost Communication with Navigation Control Module  U0233  Lost Communication with Blind Spot Monitor Master Module  U0293  Lost Communication with Hybrid Control Module  U1110  Lost Communication with Clearance Sonar Module  


DESCRIPTION

These DTCs are stored if there is a malfunction in the CAN communication system connected to the rear television camera assembly.

HINT:

If CAN communication system DTCs are stored, they may also be stored in other systems.


DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
U0126 Lost Communication with Steering Angle Sensor Module Lost communication with steering sensor CAN communication system Rear Camera B
U0140 Lost Communication with Body Control Module Lost communication with main body ECU (multiplex network body ECU) CAN communication system Rear Camera B
U0163 Lost Communication with Navigation Control Module Lost communication with radio receiver assembly*1 or radio and display receiver assembly*2 CAN communication system Rear Camera B
U0233 Lost Communication with Blind Spot Monitor Master Module Lost communication with blind spot monitor sensor RH CAN communication system Rear Camera B
U0293 Lost Communication with Hybrid Control Module Lost communication with EV control ECU CAN communication system Rear Camera B
U1110 Lost Communication with Clearance Sonar Module Lost communication with clearance warning ECU assembly CAN communication system Rear Camera B

*1: w/ Navigation system

*2: w/ Audio and visual system


PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Chassis > Rear Camera > Clear DTCs
50002 85

Result:
Proceed to
NEXT



NEXT

2.CHECK DTC OUTPUT
2.CHECK DTC OUTPUT
a.

Recheck for DTCs and check that no DTCs are output.

Chassis > Rear Camera > Trouble Codes
50001 85
HINT:
·

If CAN communication system DTCs are stored, they may also be stored in other systems.

·

If the CAN communication system has been inspected and repaired in other systems, the DTCs will not be output when rechecking for DTCs.

·

If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even if the DTCs were not output when rechecking for DTCs.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING




Result:
Result Proceed to
DTCs are not output. A
DTCs are output. B



A

B