Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM37H0E _56 Audio / Visual / Telematics _095293 PARK ASSIST / MONITORING _0455114 BLIND SPOT MONITOR SYSTEM W

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  CUSTOMIZE PARAMETERS  


CUSTOMIZE BLIND SPOT MONITOR SYSTEM


a.

Customizing with the GTS

NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Be sure to make a note of the current settings before customizing.

·

When troubleshooting a function, first make sure that the function is set to the default setting.



i.

Turn the blind spot monitor system on.


ii.

Select the setting by referring to the table below.

Warning
Tester Display Description Default Setting ECU
BSM Buzzer Volume Adjust Sets the volume of the RCTA buzzer (blind spot monitor buzzer). Medium 001:Low,011:Medium,101:High Blind Spot Monitor Sensor LH
FHL Function Turns the automatic rear flashing hazard lights function on and off. ON 0:ON,1:OFF Blind Spot Monitor Sensor RH
BSM Function Switches the blind spot monitor function on and off. Valid 0:Valid,1:Invalid Blind Spot Monitor Sensor RH
BSM Mirror Indicator Brightness Sets the brightness of the indicators in the outer rear view mirror assemblies. Bright 001:Dark,101:Bright Blind Spot Monitor Sensor RH
RCTA Function Switches the RCTA function on and off. ON 0:ON,1:OFF Blind Spot Monitor Sensor RH
BSM Approaching Vehicle Detection Timing Setting Sets the notification timing for vehicles approaching from behind the vehicle. Middle 00:Only Blind Spot,01:Late,10:Middle,11:Early Blind Spot Monitor Sensor RH
50006 7


b.

Customizing with the multi-information display

NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Be sure to make a note of the current settings before customizing.

·

When troubleshooting a function, first make sure that the function is set to the default setting.



i.

Turn the ignition switch to ON.


ii.

Turn the blind spot monitor system on.


iii.

Enter the following menus: Settings / Vehicle Settings / BSM or RCTA


iv.

Select the setting by referring to the table below.

BSM Setting
Display Description Default Setting ECU
Brightness Sets the brightness of the indicators in the outer rear view mirror assemblies. Bright Dark or Bright Blind Spot Monitor Sensor RH
Sensitivity Sets the notification timing for vehicles approaching from behind the vehicle. Middle Early, Middle, Late or Only Blind Spot Blind Spot Monitor Sensor RH

RCTA Setting
Display Description Default Setting ECU
Volume Sets the volume of the RCTA buzzer (blind spot monitor buzzer). 2 3, 2 or 1 Blind Spot Monitor Sensor LH