Home › Vehicle Exterior › WIPER / WASHER › RAIN SENSOR
RM37H0E _59 Vehicle Exterior _095212 WIPER / WASHER _0455446 RAIN SENSOR A

WIPER / WASHER  RAIN SENSOR  INSTALLATION  


PROCEDURE

Hide 89944 1.INSTALL RAIN SENSOR TAPE

Z101186

HINT:
·

Only perform this procedure when replacing the rain sensor tape.

·

Replace the rain sensor tape with new one if it is damaged or contaminated.




a.
B604496N01
0.667,0.063 0.948,0.417 0.281,0.354 18 false i 4.552,0.063 4.833,0.417 0.281,0.354 18 false ii 4.844,1.021 5.125,1.375 0.281,0.354 10 false A 5.427,1.615 5.698,1.75 0.271,0.135 10 false B

i.

Clean the rain sensor sensing portion with a piece of cloth.


ii.

Remove the peeling paper (the smaller one), and apply the rain sensor tape to the position (the rain sensor sensing portion) shown in the illustration.

NOTICE:

Apply the tape while pressing out air bubbles stuck between the sensor and the tape with a finger.


Standard Clearance:
Measurement Area Measurement Measurement Area Measurement
A 14.4 mm (0.567 in.) B 7.25 mm (0.285 in.)




Hide 89941 2.INSTALL RAIN SENSOR

Z101186

NOTICE:
·

Make sure that there is no rain sensor tape residue remaining on the windshield glass. If there is, remove the residue.

·

If there is any rain sensor tape residue remaining on the windshield glass, replace the tape.




a.
B604524C02
0.469,0.115 0.75,0.469 0.281,0.354 18 false i 4.313,0.083 4.594,0.438 0.281,0.354 18 false ii 3,3.865 3.281,4.219 0.281,0.354 18 false iii 0.438,3.615 0.719,3.969 0.281,0.354 18 false iV 4.198,2.813 4.479,3.167 0.281,0.354 18 true V
*a Stopper - -
V100135

Lock
V113147

Install in this Direction


i.

Clean the windshield glass with a piece of cloth.


ii.

When installing a new rain sensor or when the rain sensor tape has been replaced:

1.

Peel off the release sheet.

HINT:

Do not touch the silicone surface.




iii.

Gradually attach the rain sensor to the windshield glass surface in the direction indicated by the arrow shown in the illustration to prevent air bubbles from forming between them.


iv.

Push in the stopper to install the rain sensor as shown in the illustration.


v.

Connect the connector.



Hide 89943 3.INSTALL RAIN SENSOR COVER