Home › Power Source / Network › POWER DISTRIBUTION › POWER INTEGRATION SYSTEM
RM37H0E _57 Power Source / Network _095301 POWER DISTRIBUTION _0455449 POWER INTEGRATION SYSTEM U

POWER DISTRIBUTION  POWER INTEGRATION SYSTEM  DATA LIST / ACTIVE TEST  


READ DATA LIST


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


HINT:

Using the GTS to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


a.

No. 1 semiconductor power integration ECU (w/ PTC Heater)

i.

Enter the following menus: Body Electrical / Power Integration No.1 / Data List.

Body Electrical > Power Integration No.1 > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Power Supply Voltage No. 1 semiconductor power integration ECU power supply voltage value 0 to 19.68 V 8 to 14 V -
Ignition Switch Input Signal Ignition switch ON signal ON or OFF ON: Ignition switch ON
OFF: Ignition switch off
"OFF" is also displayed for this item when the ignition switch ACC.
Headlight ECU LH Input Signal Headlight ECU sub-assembly LH input condition ON or OFF ON: Headlight ECU sub-assembly LH is input
OFF: Headlight ECU sub-assembly LH is not input
-
Headlight ECU RH Input Signal Headlight ECU sub-assembly RH input condition ON or OFF ON: Headlight ECU sub-assembly RH is input
OFF: Headlight ECU sub-assembly RH is not input
-
A/C Magnetic Clutch Input Signal Compressor with motor assembly (magnetic clutch) input condition ON or OFF ON: Compressor with motor assembly (magnetic clutch) is input
OFF: Compressor with motor assembly (magnetic clutch) is not input
Displayed in the GTS, but the display does not change because it is not applicable
A/C Water Pump Input Signal Heater accessory assembly (heater water pump assembly) input condition ON or OFF ON: Heater accessory assembly (heater water pump assembly) is input
OFF: Heater accessory assembly (heater water pump assembly) is not input
-
Headlight ECU LH Output Signal Headlight ECU sub-assembly LH output condition ON or OFF ON: Headlight ECU sub-assembly LH has power supply
OFF: Headlight ECU sub-assembly LH has no power supply
-
Headlight ECU RH Output Signal Headlight ECU sub-assembly RH output condition ON or OFF ON: Headlight ECU sub-assembly RH has power supply
OFF: Headlight ECU sub-assembly RH has no power supply
-
A/C Magnetic Clutch Output Signal Compressor with motor assembly (magnetic clutch) output condition ON or OFF ON: Compressor with motor assembly (magnetic clutch) is on
OFF: Compressor with motor assembly (magnetic clutch) is off
Displayed in the GTS, but the display does not change because it is not applicable
A/C Water Pump Output Signal Heater accessory assembly (heater water pump assembly) output condition ON or OFF ON: Heater accessory assembly (heater water pump assembly) is on
OFF: Heater accessory assembly (heater water pump assembly) is off
-
Headlight ECU LH Output Current Headlight ECU sub-assembly LH current Min.: 0, Max.: 255 A Below 8 A Headlight ECU sub-assembly LH current when output is on
Headlight ECU RH Output Current Headlight ECU sub-assembly RH current Min.: 0, Max.: 255 A Below 8 A Headlight ECU sub-assembly RH current when output is on
A/C Magnetic Clutch Output Current Compressor with motor assembly (magnetic clutch) current Min.: 0, Max.: 255 A Below 4 A Displayed in the GTS, but the display does not change because it is not applicable
A/C Water Pump Output Current Heater accessory assembly (heater water pump assembly) current Min.: 0, Max.: 255 A Below 4 A Heater accessory assembly (heater water pump assembly) current when output is on
Status of Headlight ECU LH Fuse Headlight ECU sub-assembly LH fuse condition Disconnect or Connect Disconnect: Fuse shut off
Connect: Fuse not shut off
-
Status of Headlight ECU RH Fuse Headlight ECU sub-assembly RH fuse condition Disconnect or Connect Disconnect: Fuse shut off
Connect: Fuse not shut off
-
Status of A/C Magnetic Clutch Fuse Compressor with motor assembly (magnetic clutch) fuse condition Disconnect or Connect Disconnect: Fuse shut off
Connect: Fuse not shut off
Displayed in the GTS, but the display does not change because it is not applicable
Status of A/C Water Pump Fuse Heater accessory assembly (heater water pump assembly) fuse condition Disconnect or Connect Disconnect: Fuse shut off
Connect: Fuse not shut off
-
Headlight ECU LH Fuse Shut Off History Headlight ECU sub-assembly LH fuse shut off history ON or OFF ON: Fuse has shut off history
OFF: Fuse has no shut off history
-
Headlight ECU RH Fuse Shut Off History Headlight ECU sub-assembly RH fuse shut off history ON or OFF ON: Fuse has shut off history
OFF: Fuse has no shut off history
-
A/C Magnetic Clutch Fuse Shut Off History Compressor with motor assembly (magnetic clutch) fuse shut off history ON or OFF ON: Fuse has shut off history
OFF: Fuse has no shut off history
Displayed in the GTS, but the display does not change because it is not applicable
A/C Water Pump Fuse Shut Off History Heater accessory assembly (heater water pump assembly) fuse shut off history ON or OFF ON: Fuse has shut off history
OFF: Fuse has no shut off history
-
The Number of DTCs Number of trouble codes Min.: 0, Max.: 255 Number of DTCs displayed -


b.

No. 2 semiconductor power integration ECU

i.

Enter the following menus: Body Electrical / Power Integration No.3 / Data List.

Body Electrical > Power Integration No.3 > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Power Supply Voltage No. 2 semiconductor power integration ECU power supply voltage value 0 to 19.68 V 8 to 14 V -
Ignition Switch Input Signal Ignition switch ON signal ON or OFF ON: Ignition switch ON
OFF: Ignition switch off
"OFF" is also displayed for this item when the ignition switch ACC.
Tail Input Signal Headlight dimmer switch (TAIL) input condition ON or OFF ON: Headlight dimmer switch in tail or head position
OFF: Headlight dimmer in neither tail or head position
-
Stop Light Input Signal Stop light switch assembly input condition ON or OFF ON: Brake pedal depressed
OFF: Brake pedal released
-
Emergency Brake Input Signal Emergency brake signal operation condition ON or OFF ON: Emergency brake signal is on
OFF: Emergency brake signal is off
-
Radar Cruise Input Signal Radar cruise operation condition ON or OFF ON: Radar cruise system is operating
OFF: Radar cruise system is not operating
-
Rear Fog Light Input Signal Headlight dimmer switch (rear fog light switch) input condition ON or OFF ON: Headlight dimmer switch (rear fog light switch) is on
OFF: Headlight dimmer switch (rear fog light switch) is off
Displayed in the GTS, but the display does not change because it is not applicable
Rear Defogger Input Signal Rear defogger input condition ON or OFF ON: Rear defogger is operating
OFF: Rear defogger is not operating
-
Back-up Light Input Signal Back-up light input condition ON or OFF ON: Shift lever in R
OFF: Shift lever in any position other than R
-
Tail Welcome Light Input Signal Taillight input condition ON or OFF ON: Welcome light is operating
OFF: Welcome light is not operating
-
Stop Light Output Signal Stop light output condition ON or OFF ON: Stop light is on
OFF: Stop light is off
Stop lights blink during emergency brake signal control
Rear Fog Light Output Signal Rear fog light output condition ON or OFF ON: Rear fog light is on
OFF: Rear fog light is off
Displayed in the GTS, but the display does not change because it is not applicable
Rear Defogger Output Signal Rear defogger output condition ON or OFF ON: Rear defogger is on
OFF: Rear defogger is off
-
Back-up Light Output Signal Back-up light output condition ON or OFF ON: Back-up light is on
OFF: Back-up light is off
-
Tail Light No.1 Output Signal Taillight output condition ON or OFF ON: Taillight is on
OFF: Taillight is off
Taillights blink while welcome light is operating
Stop Light Output Current Stop light current Min.: 0, Max.: 255 A Below 2 A Stop light switch assembly current when output is on
Rear Fog Light Output Current Rear fog light current Min.: 0, Max.: 255 A Below 2 A (varies depending on load conditions; value indicated as reference only) Displayed in the GTS, but the display does not change because it is not applicable
Rear Defogger Output Current Rear defogger current Min.: 0, Max.: 255 A Below 25 A Rear defogger current when output is on
Back-up Light Output Current Back-up light current Min.: 0, Max.: 255 A Below 2 A Back-up light current when output is on
Tail Light No.1 Output Current Taillight current Min.: 0, Max.: 255 A Below 2 A Taillight current when output is on
Status of Stop Light Fuse Stop light fuse condition Disconnect or Connect Disconnect: Fuse shut off
Connect: Fuse not shut off
-
Status of Rear Fog Light Fuse Rear fog light fuse condition Disconnect or Connect Disconnect: Fuse shut off
Connect: Fuse not shut off
Displayed in the GTS, but the display does not change because it is not applicable
Status of Rear Defogger Fuse Rear defogger fuse condition Disconnect or Connect Disconnect: Fuse shut off
Connect: Fuse not shut off
-
Status of Back-up Light Fuse Back-up light fuse condition Disconnect or Connect Disconnect: Fuse shut off
Connect: Fuse not shut off
-
Status of Tail Light No.1 Fuse Taillight fuse condition Disconnect or Connect Disconnect: Fuse shut off
Connect: Fuse not shut off
-
Stop Light Fuse Shut Off History Stop light fuse shut off history ON or OFF ON: Fuse has shut off history
OFF: Fuse has no shut off history
-
Rear Fog Light Fuse Shut Off History Rear fog light fuse shut off history ON or OFF ON: Fuse has shut off history
OFF: Fuse has no shut off history
Displayed in the GTS, but the display does not change because it is not applicable
Rear Defogger Fuse Shut Off History Rear defogger fuse shut off history ON or OFF ON: Fuse has shut off history
OFF: Fuse has no shut off history
-
Back-up Light Fuse Shut Off History Back-up light fuse shut off history ON or OFF ON: Fuse has shut off history
OFF: Fuse has no shut off history
-
Tail Light No.1 Fuse Shut Off History Taillight fuse shut off history ON or OFF ON: Fuse has shut off history
OFF: Fuse has no shut off history
-
The Number of DTCs Number of trouble codes Min.: 0, Max.: 255 Number of DTCs displayed -