Home › Power Source / Network › NETWORKING › LIN COMMUNICATION SYSTEM
RM37H0E _57 Power Source / Network _095302 NETWORKING _0455450 LIN COMMUNICATION SYSTEM U

NETWORKING  LIN COMMUNICATION SYSTEM  DATA LIST / ACTIVE TEST  


READ DATA LIST


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


HINT:

Using the GTS to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


a.

According to the display on the GTS, read the Data List.

Body Electrical > Main Body > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Communication D-Door Motor Connection status between front power window regulator motor assembly LH and main body ECU (multiplex network body ECU) OK or STOP OK: Connection
STOP: No connection
DTC is output if an error occurs in LIN communication.
Communication P-Door Motor Connection status between front power window regulator motor assembly RH and main body ECU (multiplex network body ECU) OK or STOP OK: Connection
STOP: No connection
DTC is output if an error occurs in LIN communication.
Communication RR-Door Motor Connection status between rear power window regulator motor assembly RH and main body ECU (multiplex network body ECU) OK or STOP OK: Connection
STOP: No connection
DTC is output if an error occurs in LIN communication.
Communication RL-Door Motor Connection status between rear power window regulator motor assembly LH and main body ECU (multiplex network body ECU) OK or STOP OK: Connection
STOP: No connection
DTC is output if an error occurs in LIN communication.
Communication Slide Roof Connection status between sliding roof drive gear sub-assembly and main body ECU (multiplex network body ECU) OK or STOP OK: Connection
STOP: No connection
DTC is output if an error occurs in LIN communication.
Communication Master SW Connection status between multiplex network master switch assembly and main body ECU (multiplex network body ECU) OK or STOP OK: Connection
STOP: No connection
DTC is output if an error occurs in LIN communication.
The Number of DTC Number of trouble codes Min.: 0, Max.: 255 Number of DTCs displayed -