When an internal malfunction is detected in the certification ECU (smart key ECU assembly), this DTC will be output. This DTC is also stored as a past DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| B278C | Lost Communication with Power Source Control | Certification ECU (smart key ECU assembly) internal malfunction | Certification ECU (smart key ECU assembly) | Entry&Start | A |
When using the GTS with the ignition switch off to troubleshoot:
Connect the GTS to the vehicle and turn a courtesy light switch on and off at 1.5 second intervals until communication between the GTS and vehicle begins.
Before replacing the certification ECU (smart key ECU assembly) or steering lock actuator assembly, refer to the immobiliser system.
Pre-procedure1
Clear the DTCs.
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| B278C is not output | A |
| B278C is output | B |
Post-procedure1
None
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B