Home › Power Source / Network › NETWORKING › CXPI COMMUNICATION SYSTEM
RM37H0E _57 Power Source / Network _095302 NETWORKING _0455451 CXPI COMMUNICATION SYSTEM L

NETWORKING  CXPI COMMUNICATION SYSTEM  PRECAUTION  


PRECAUTION FOR SEMICONDUCTOR POWER INTEGRATION ECU


a.

Do not remove or install the semiconductor power integration ECU with the negative (-) auxiliary battery terminal connected.

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When disconnecting and reconnecting the auxiliary battery.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART


·

Some parts must be initialized and set when replacing or removing and installing parts.

Click hereGeneral>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>WORK PROCEDURE




b.

Make sure that the semiconductor power integration ECU is not exposed to water, as it is not waterproof.


c.

Some load is connected to a dedicated circuit to prevent overcurrent. Therefore, parts other than those specified for the vehicle may not be able to be used.


d.

When replacing the semiconductor power integration ECU, the system may not operate normally if the same part number is not used.


e.

Check that systems are operating normally before proceeding with troubleshooting.