Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE ACTUATOR
RM37H0E _54 Brake _096946 PARKING BRAKE _0455460 ELECTRIC PARKING BRAKE ACTUATOR G

PARKING BRAKE  ELECTRIC PARKING BRAKE ACTUATOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT ELECTRIC PARKING BRAKE ACTUATOR ASSEMBLY

HINT:

Using the GTS to perform the Active Tests allows relays, VSVs and actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch on.


d.

Turn the GTS on.


e.

Enter the following menus: Chassis / Brake EPB / Active Test.


f.

When the vehicle's tires are lifted off the ground and the GTS is used to operate the electric parking brake actuator assembly, check the condition of the rear tires.


g.

According to the display on the tester, perform the Active Test.

Chassis > Brake/EPB > Utility
Tester Display
EPB Control Switch
50005 435 5556
OK:
Tester Display Condition of the Rear Tire
Lock Lock
Release Free


If the result is not as specified, inspect the electric parking brake actuator assembly.

Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING


h.

Turn the ignition switch on, pull the electric parking brake switch assembly to the lock side for 1 second and check that the parking brake indicator light (red) illuminates.


i.

Push the electric parking brake switch assembly to the release side for 1 second and check that the parking brake indicator light (red) turns off.


j.

Also, check that the brake warning light / yellow (minor malfunction) does not illuminate at this time.