Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE SWITCH
RM37H0E _54 Brake _096946 PARKING BRAKE _0455461 ELECTRIC PARKING BRAKE SWITCH G

PARKING BRAKE  ELECTRIC PARKING BRAKE SWITCH  INSPECTION  


PROCEDURE

Hide 84390B 1.INSPECT ELECTRIC PARKING BRAKE SWITCH ASSEMBLY

a.

Check the resistance.

i.
C398938C47
1.51,0.094 1.969,0.333 0.458,0.24 2.594,0.833 2.188,1.094 true 2.583,1.49 2.188,1.292 true 1.969,1.031 2.281,0.469 true 2.24,1.75 1.969,1.354 true 2.635,1.427 3.083,1.667 0.448,0.24 10 false SWI1 0.188,0.125 0.5,0.323 0.313,0.198 10 false *a 2.635,0.74 3.083,0.979 0.448,0.24 10 false SWI2 2.271,1.75 2.792,1.969 0.521,0.219 10 false SWO1 2.323,0.323 2.844,0.542 0.521,0.219 10 false SWO2 1.604,0.125 1.917,0.323 0.313,0.198 10 false D51
*a Component without harness connected
(Electric Parking Brake Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(D51)Location & Routing

Click Connector(D51)Instrument Panel>Instrument Panel Wire>Electric Parking Brake Switch Assembly

D51-7 (SWI1) - D51-8 (SWO1) OFF (Release) 100 kΩ or higher
ON (Lock) 10 Ω or less
Switch not operated 100 kΩ or higher
D51-7 (SWI1) - D51-1 (SWI2) OFF (Release) 10 Ω or less
ON (Lock) 10 Ω or less
Switch not operated 100 kΩ or higher
D51-7 (SWI1) - D51-2 (SWO2) OFF (Release) 10 Ω or less
ON (Lock) 100 kΩ or higher
Switch not operated 10 Ω or less
D51-1 (SWI2) - D51-8 (SWO1) OFF (Release) 100 kΩ or higher
ON (Lock) 10 Ω or less
Switch not operated 10 Ω or less
D51-1 (SWI2) - D51-2 (SWO2) OFF (Release) 10 Ω or less
ON (Lock) 100 kΩ or higher
Switch not operated 100 kΩ or higher


If the result is not as specified, replace the electric parking brake switch assembly.