When coolant (Toyota genuine FC stack coolant (Pre-mixed)) is hot, do not remove the radiator cap sub-assembly.
Fluid and steam may spray out due to high pressure, possibly resulting in burns.
16475C
1.INSPECT RESERVE TANK CAP
| *a | Rubber Packing |
| *b | Gasket |
Visually check the reserve tank cap.
If there are water stains or foreign matter on the rubber packing, clean it with water and finger scouring.
Perform the work by hand.
Check that the gasket is not deformed, cracked or swollen.
Measure the valve opening pressure.
Apply a new coolant (Toyota genuine FC stack coolant (Pre-mixed)) to the gasket and rubber packing before using a radiator cap tester.
Install the reserve tank cap to the radiator cap tester.
| *1 | Reserve Tank Cap |
| *a | 30° or more |
| *b | Radiator Cap Tester |
Pump the radiator cap tester several times, and check the maximum pressure.
1 pump per second
| Item | Specified Condition |
|---|---|
| Standard pressure
(for brand-new reserve tank cap) |
94 to 122 kPa
1.0 to 1.2 kgf/cm2 14 to 18 psi |
| Minimum pressure
(for used reserve tank cap) |
94 kPa
1.0 kgf/cm2 14 psi |
Using the radiator cap tester, tilt it upward 30° or more.
Even if the reserve tank cap cannot maintain the maximum pressure, it is not a defect.
If the maximum pressure is less than the minimum pressure, replace the reserve tank cap.