When a malfunction is detected between various ECUs and sensors, these DTCs are stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| U012587 | Lost Communication With Multi-axis Acceleration Sensor Module Missing Message | 3 seconds after the ignition switch is turned to ON, while the vehicle is being driven at 1 km/h or 1 mph or more, a communication error between the yaw rate sensor (airbag ECU assembly) and the forward recognition camera is detected for 5 seconds or more. | CAN communication system | Front Recognition Camera | B |
| U012687 | Lost Communication with Steering Angle Sensor Module Missing Message | 3 seconds after the ignition switch is turned to ON, a communication error between the steering sensor and the forward recognition camera is detected for 5 seconds or more. | CAN communication system | Front Recognition Camera | B |
| U012987 | Lost Communication with Brake System Control Module Missing Message | 3 seconds after the ignition switch is turned to ON, a communication error between the No. 2 skid control ECU (brake actuator assembly) and the forward recognition camera is detected for 5 seconds or more. | CAN communication system | Front Recognition Camera | B |
| U014087 | Lost Communication with Body Control Module Missing Message | 3 seconds after the ignition switch is turned to ON, a communication error between the main body ECU (multiplex network body ECU) and the forward recognition camera is detected for 5 seconds or more. | CAN communication system | Front Recognition Camera | B |
| U029387 | Lost Communication with Hybrid/EV Powertrain Control Module Missing Message | 3 seconds after the ignition switch is turned to ON, while the vehicle is being driven at 1 km/h or 1 mph or more, a communication error between the EV control ECU and the forward recognition camera is detected for 5 seconds or more. | CAN communication system | Front Recognition Camera | B |
Pre-procedure1
None
Procedure1
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
Post-procedure1
None
NEXT
Pre-procedure1
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
Post-procedure1
None
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING